Search results

I had just came in from racing saturday night and my lady is fascinated playing with the purge she thinks it's "neat" and me still being relatively new to nitrous I'm still weary of it and how it operates but long story short I walked inside to settle down and get cleaned up and asked if she...

Finally!!!! Cams and tune is finished. Car made 301hp and 304 torque and on spray it made 370hp 405 torque!!! On stock injectors even :p ill get a video up tommorrow but the bananas part is it doesnt really sound like a cammed gt. Its very very minimal on the cam lope has me half ass tempted to...

Thanks, ill post pics and a vid soon. I was hesitant about doing cams and not the bottom end but the motor is still really healthy at 132k it seems. I figured id get a little more out of it on the stock bottom end and knock out a few other things like the transmission and change to a upr k...

Unknown atm, the cams should be done this week. Last dyno pulls it made was around 350hp and 413 torque. Ill post numbers when complete. Everytime I track it I run into a small issue though so no timeslips worth a damn :(.

Curious if I got enough mods now to finally maybe see a gain out of changing my intake manifold? Thoughts or recommendations for my set up? Car is currently a full bolt on gt on a 75 wet shot. I'm really more so of looking as to what to do next other than build the bottom end at this time. Its...

Basically on cold starts or most initial starts after sitting 30 or more minutes my a/f ratio likes to idle around 10.6, when it warms up it goes back to normal 14.5/14.7. It hadn't been doing this before but it seems odd that it wants to do it now. Car isn't throwing any codes either. Do you...

Put the change in results for those that did care or we're curious to see the changes that the car made. I'm somewhat satisfied, I'm thrilled with what the motor made kinda disappointed in the torque loss on the spray.

Last time I posted I made 253 hp 288 torq on motor and 322 hp and 403 torq on a 75 shot of spray with the bolt on's listed in my sig. This go around I should be finished up and back on the dyno by friday. Additional mods and changes are ceramic mac long tube headers, lethal performance o/r...

Hah, Im soon to be tackling the same project as you and we're close to being on the same page. My next bet was gonna be testing my luck with a small layer of foam fill and shaving it down to where I could get a flat surface to work off of and glue a piece of fabric to the foam fill and then...

I do have one question for the nitrous guys, thoughts on a window switch? is that something I should look into picking up just as another safety net or does it not really matter just never go WOT below 3k. I'm more so concerned about getting a little too foot greedy at the track I tend to roll...

Its the 3.90 gears and flywheel swap that make all that torque available :-p j/k . I sadly haven't been able to drive it that much when I was getting it tuned and all that stuff I had a few things I needed to fix I lacked the purge kit , I had to go back and drop the fuel tank because my gas...

Dunno why It isn't letting me flip that picture right side up. But to make it easier it the car put down 253hp and 293 torq on the motor and on the 75 shot it hit 322hp and 403 torq. Heres a short clip of it as well on a motor run View: https://youtu.be/StaM309Oebc

Hah woops thanks!

Ill get a small video uploaded later but I'm well satisfied on a 75shot, I'm hoping getting a purge valves takes some of the spiking out as well.

If you'd like I can post a video of my set up. I love my o/r x-pipe despite the installation being a pain in the butt. It can be a nuisance sometimes like if you wanna talk on your phone and drive but other than that I've got nothing but compliments from my coworkers and friends.

Ouch you think I'll really dyno that low? Most bolt on 4.6 dyno runs I've seen sit in the 235+ range, I could be wrong not that it really matters worst case if not satisfied spray a bigger shot right? :D

Completely useless thread kind of just excited and wondering what kinda numbers you think Im gonna throw with my mods in my sig and a 75 shot. Im hoping i can hit atleast 315 or more :D. Also curious of thoughts of a different color for my car Im going to plastidip the whole thing either matte...

Eh to each their own, I'm soon to be 31 myself do I like the thoughts of it being in the cab with me not really, but I love my music and the quality of it so ditching the sub is a no go :-p. And no I don't need the rear seat delete kit its a matter of preference to keep either the Driver seat or...

Its actually turning out to be a pain in the butt :( I kind of need the rear seat delete kit but even then I need some sort of bracing and different material I would think. Atm looking at mounting it in the floorboard now beings I'm a towering 5'7" I still got plenty of space to put it just...

Thanks for the input, looks like its that option or the ole diy guides and a different material :-p.