Search results

A backwards head gasket will cause car to overheat, the coolant climbs to 280 degees qiuckly. The pressure will build blow out of coolant overflow tube as well as radiator cap.

check out stolonandrecovery.com> It took me about 5 hours

I am using UPR pro series control arms. Not Team Z (Good from what I hear). For the drag strip they are great. However having a solid bushing design, the pivot points are needed for hard acceleration on sloped on ramps. IMOA this is where my solid bushings are limited. I have a slanted driveway...

I bought a new ccrm from autozone $85 MT1073. Lasted 1 year 2 months. I know you can buy one from junk yard and dealer. Has anybody bought one from Advance auto cardone 73-70020? It is a cross reference to part#F6SZ-12B577-AA

Thank you. I have been playing with adjustment for the last week. I have added slack but not inch or so. Ill give it a shot.

Should the throw out bearing touch the clutch diaphram? If is to loose I get the squaeling sound. To tight it can wear it out right? Triple hook quadrant- set in middle Adjustable cable new- pinch cable and twist with finger about 1/4 inch Fire wall adjuster- left plenty of adjustment New...

I have stock springs and as far as I know the shocks/struts are to. I havent changed them only having the car a year. My car is doing the exact same thing. There is a 1-1/2 difference from driver rear to passenger rear. The driver side sits higher. Im not worried when I get springs, control...

Not sure size of fitting. You can pick up a aftermaket gauge with fittings around $15 bucks. The two places you can put the guage is in the water neck bleeder bolt. (if it wasnt stripped). The only thing is that location would not read until thermastat opened. The other place is the temperature...

I had a similair problem. It took me a good hour or 2 to bleed air out. I bought a radiator cap with lever release and burped air out with bleeder bolt on top of new waterneck housing. Check to see if your over flow tank is not cracked and filled to capacity. When stat opens it will suck in...

My low speed fan was not kicking on. My car had a 117 code. So i replaced the coolant tempature sensor. It was still under warranty. Now it works. The problem is alot less than before. In the morning it will still hesitate. I will check the voltage. I also live in Florida. I cleaned my Iat...

Im not sure what the ECT calibration is. It only started doing it about a month ago.

When I start car after it has been sitting overnight and at work it idles fine. When I give it gas it stumbles and hesitates. If I back off the throttle and ease into to it the car smothes out. After a tenth of a mile no problems and car is smooth. I have cleaned MAF and barely made a...

I just bought new oxygen sonsors in february. Still under warranty I will exchange them and try it.

Which side is bank 2?

Ive pulled codes as well and mine also has 564. Where is pin 12 located on CCRM? Will having a 116 code cause problems with fan? Thank you

Napa has new rotors priced well. Ill go with ceramic pads. Thank you

Time to do brakes. Do you get better stopping power. Less brake fade. Worth the money? Car is daily driver and stock.

I used a after market oil pressure guage from autometer.

I would go to the local autoparts store and purchase a mechanical temp guage. Run it in the car for about a week. There about 15-20 bucks. Also when the car reaches operating tempature reach down (Be careful hot) feel the bottom of the radiator. If it is cold and the top of the radiator is hot...

120,000 miles stock valve train, stock motor