Search results

  1. fivemustangs

    What Length Pushrods With My Setup

    Hey all, before you say anything I have ordered my pushrod length measuring tool. But I have never used one before and want to know if anyone has setup the same as myself. I am running a stock bottom end with a TFS stage 1 cam and 200cc cast roush heads, made by World. 1.6 stud mount roller...
  2. fivemustangs

    What is redline with my mods? Nitrous

    Sounds good, thinking 5400 since I still have stock heads and valve springs. Thanks for the info!
  3. fivemustangs

    What is redline with my mods? Nitrous

    Anyone know what a safe but effecient shifting point would be with nitrous 5000, 5200, 5400?
  4. fivemustangs

    What is redline with my mods? Nitrous

    I am adding nitrous to my 91 GT, I plan on running a 100 shot with my NOS wet kit. I have a trickflow street heat intake, 70mm TB, BBK cold air intake, 70mm MAF, trickflow stage 1 cam, off road X pipe, flowmaster mufflers and stock heads for now........ The nitrous kit is all wired up with a NOS...
  5. fivemustangs

    Expired 94/95 5.0 Bellhousing

    Sorry not sure how to upload pictures, buy all info and picture can be found here http://www.ebay.com/itm/151005173652?ssPageName=STRK:MESELX:IT&_trksid=p3984.m1555.l2649 call or text 207-479-423five coming from ellsworth maine.
  6. fivemustangs

    Expired 94/95 5.0 Bellhousing

    I have a 94/95 5.0 bellhousing for sale in great shape cleaned and primed ready for install. $130 free shipping!
  7. fivemustangs

    2001 t5 in my 91 fox

    I agree, after more searching i found there is no way but to replace the tailshaft housing with a 92-98matxh t5 housing and the tailshaft would have to be drilled or scored for the new speedo gear to be attached. Just picked up a 88 t5 for a good price, will sell 01 t5. Thanks
  8. fivemustangs

    2001 t5 in my 91 fox

    I am going to be swapping a T5 from a 2001 Mustang v6 into my 91 fox. I know I need to swap the input shafts, but I was wondering what I should do for the tailshaft housing? the 99-04 T5's have the electric speedo and does not look like I can put my mechanical cable in the 2001 T5's VSS...
  9. fivemustangs

    Were did you mount your methanol pump???

    I am using the stock tank for my methanol it is the better choice, But I am still trying to find a good mounting place for the pump in the drivers side fender. Also it said on the snow performance page to mount the pump at the same level or lower then the tank?
  10. fivemustangs

    Were did you mount your methanol pump???

    I got my stage 2 snow performance kit the other day in the mail. I am using my existing windshield wiper tank for my methanol but need to fine a place to mount my pump? I am trying to put it in the drivers side fender well some place and do not want to mount it in the trunk but do want to keep...
  11. fivemustangs

    Tuning for Methanol injection?

    So i was also wondering, how would i wire this switch into the ECU? To tell it to run more timing or not and were can i find the switch?
  12. fivemustangs

    Tuning for Methanol injection?

    I thought about the washer fluid but i only put about 3k the on this car a year so i think im just gunna go wit the boost juice its about 10 a gallon. I will see how much i go through then change it up if it gets to expensive next year...
  13. fivemustangs

    Tuning for Methanol injection?

    Well with all that said i guess all i would need now is to find some kind of wiring diagram..........thank you, your information has been very helpful.
  14. fivemustangs

    Tuning for Methanol injection?

    Yes that explains a lot, but would I have to mount the meth nozzle before the IAT to get the correct reading with the methanol cooling the charge?
  15. fivemustangs

    Tuning for Methanol injection?

    Ya I am intercooler and have a blow-through MAF which has the IAT sensor built onto it. If the ECU was going to pull timing it would be because that sensor was relaying to the ECU that the intake temps were to high. But I can see injectiong water into the MAF might cause some problems...... But...
  16. fivemustangs

    Tuning for Methanol injection?

    I have a procharged 02 GT I want to put methanol on this spring to add a little power and safety to my engine. I was wondering if my tuner could tune the ECU to pull timing if there was a pump failer or low pressure in the system to prevent from detonation? I was looking at "safe injection" from...
  17. fivemustangs

    Cobra chin spoiler

    I am looking at getting a 03/04 cobra front bumper for my 02 GT and noticed that most of the chin spoilers are more then the bumper! I saw on ebay that they have one listed for the GT and cobra for around $100........So I was wondering if they were the same chin spoiler? or should I stay away...
  18. fivemustangs

    t5 bellhousing spacer

    But after more searching I think I am going to just change out the input shaft like you said because I already have to do the tail shaft so I can keep the speedo in the car.
  19. fivemustangs

    t5 bellhousing spacer

    I have a friend that is running a 95 t5 in his 79 mustang with no prob. I dont think it is an issue if you run the right bellhousing from a 94-95 gt. But I see what you mean with the tranny being 5/8" longer you could run into hitting the shaft on the back of the tranny. But there seems to be...
  20. fivemustangs

    t5 bellhousing spacer

    Why would you have to make the driveshaft shorter? Im pretty sure they are listed at the same length as a fox shaft, thats why they made the bellhousing and input shaft longer on the an95 transmissions.
Top Bottom
Back
Forums
Menu