Search results

I am trying to add a Vent Guage to my 2011 5.0 and am unsure where I can cleanly tap a 12 volt switched power supply in my mustang. Any help would be greatly appreciated. Also if you know how to tap into the headlight dimming system that would also be greatly appreciated. Thanks in advance.

Definately want to know how much that set up is.

How is the fitment and quality on the Steeda's. Are the Roush neighborhood disturbing loud or just muscle car loud.

I am looking to purchase axleback exhaust for my 5.0. I have watched almost every video I can find but was hoping you guys can give me more specific answers. I am down to the Flowmaster Hushpowers and the Roush. I enjoy the sound I have heard from both I have no clue just how loud they are...

I picked up my 5.0 last Thursday. I have put about 250 miles on it since then. As of yesterday my clutch pedal began squeaking when I depress it. I took it into Ford and they are telling me the whole clutch pedal assembly needs to be replaced. My replacement should be here on Monday. I have...

+1 on Northern. I do believe Summit brand is Northern. I run one and have been extremely happy with it.

I am installing new hydraulic lifters in a 78' 302. Can anyone tell me wether or not these need to be soaked in oil over night or just dipped. I have heard both and not sure which is the correct procedure. Thanks in advance

So I removed the rockers and checked that each pushrod is straight. Reintalled each rocker, and started the engine. I Now have even loader clatter in that I think the rockers were installed wrong. Can anyone tell me the proper procedure for installing and adjusting pedestal rockers on a 78'...

If video if this would help just let me know.

Okay I popped the valve covers off today. And some of my pushrods spin freely by hand. I would say that I can spin at least half of them with ease by hand. There seems to be no up and down play though. I went ahead and started the car with the covers off and noticed that one of the pushrods is...

I will check that, I also replaced the header gasket and the noise is persisting.

Motor was rebuilt about 4 or 5 years ago. So there should be less than 10,000 miles. But the mechanic I used was...not the most wonderful, so I have my doubts he did what he claimed. Most everything else he did I have either replaced or fixed on my own.

Hello, I recently fired my mustang and noticed I now have a knocking noise coming from the engine. I was wondering if anyone on here can help me identify it. Engine work is not my strongest suit and I am on a learning curve here. Any help would be greatly appreciated. I have uploaded a...

I will give that a try. What you described sounds like what is wrong with mine about being tilted a bit forward.

So, if I am understanding this, I bend them straight. Does anyone have pictures of theirs mounted.

Here is some pictures I think this may help show what I am talking about.

I picked up a set of hood pins for my 65 today. I mounted them where the original hood stops are. They fit great but sit at a slight angle. Is this an issue or is there a way to straighten them out? Just wanted some advice on this before I start drilling the hood. I can post pictures if...

Here is a picture of the complete harness I do have on hand. Probably not much help. Will get better pics later. The other harness the one pictured in the last picture. Is located on the far side towards the passenger door almost at the end of the harness. I circled its area in red as best...

Barnstang, I really appreciate the help. I will be able to post up more pictures of the harness around noon today, when I get home. But what you have given so far has helped quite a bit. The diagrams I am using I found linked to on this site. Can't remember the exact page. I am using...

Ok so the all pink wire that I labeled Tach connects to the red wire off the ignition, correct? Once again thanks for your input, this is not my strong suit and I am trying to learn it.