Search results

  1. S

    Headers

    I also have the headmans for a 302 5.0 roller carbed and t5. Can I ask what exhaust system you hooked up or is it custom. Thinking of the RMP Cable kit? How hard is it to make your own? Thanks
  2. S

    Pro Comp Distributor

    Has anyone used one of these and will it work with e303 roller cam? They state that it will and it has a steel gear. Ford 289 / 302w Ready to Run w/Vacuum
  3. S

    oil sender switch

    I just finished dropping in a 91 302 carbed motor in a 68 coupe. My question is can I use this oil sender switch(lights) image attached or do I need to go with the older 68 fitting (hex pipe) and sender unit (gauge).
  4. S

    T5 transmission fluid

    Thank you all, very helpful!!!!
  5. S

    T5 transmission fluid

    Ok, I was about to attach my T5 to my 302 and place it into my car. I was told it would be easier to fill the T5 with fluid before I set the engine with T5 into the engine compartment. Ok, so I started to fill the T5 and to my surprise it started to come out of the tail shaft, is this normal? I...
  6. S

    Bellhousing bolt size?

    Thanks for the bolt sizes, can I buy these at any auto parts store? Also attached is a image of two bottom bolt holes, are these the same as the starter bolts? And one last thing should I use lock washers? Thanks
  7. S

    Bellhousing bolt size?

    No, the 6-bolt bellhousing to the block.
  8. S

    Bellhousing bolt size?

    Have an 89 T5 and bellhousing without the bolts, trying to locate size and where to purchase the bolts. The block is a 91 302 roller, carbed that will be dropped into a 68 coupe. Any help would be great. Thanks
  9. S

    E7TE Ported or GT40 OR GT40P

    My friend has a set of DO0E 58cc 1.94 and 1.6 heads would these be a good choice
  10. S

    E7TE Ported or GT40 OR GT40P

    On a tight budget and I need help in selecting heads for my 91 302 roller .030 9.5:1 e303 cam Hydraulic roller lifters double timing chain. Plan on a dual plane intake, 600 carb and shorty headers, backed by a t5 tranny. I also need help on what roller rockers and push rod length to use. Any...
Top Bottom
Back
Forums
Menu