Search results

  1. D

    car pops when going down road

    timing was off so that took car of the popping but time to rebuild car.... whent to start it friday @ lunch to go to bank and it cault on fire
  2. D

    car pops when going down road

    when going down the road if i ease on the gas my car pops but if i down shift and get on it it pulls really good with no problem . stsrted this about a week ago then stopped and when going around a car about 40 mph today it did it again untill i got on it a little more. car runs good most of...
  3. D

    BBK Performance SSI Intake

    bbk intake coming off and stock going back on . if im only going to run a 13.9 then i'll be ok with the stock. plus there's about a qourt of laying in ths lower intake as i write this and the intake is some how sucking oil into it's self and pushing it into the combustion chambers making my car...
  4. D

    BBK Performance SSI Intake

    ok went to track first pass [email protected] timing @14 tps@8 track temp 167, humidity 130 baro 31.25 second pass [email protected] timing@22 tps@9 tires @21 track temp 167,humidity130,[email protected] third pass [email protected] timing@22,tps@5 tires @21 track temp 167,humidity 130,baro 31.25 still not...
  5. D

    BBK Performance SSI Intake

    i'll be going back to the track tomorrow since it's been raining here on fridays for the past two weeks. i'll let you all know what the car runs after fixing vacuum leake. hopefully it'll do better then 13.84
  6. D

    code 63?

    this info came from motorbooks workshop how to tune and modify ford fuel injection
  7. D

    code 63?

    code 63: the KOEO code 63 indicates the TP signal voltage is low. disconnect the TP sensor harness. place a jumper wire between the VREF wire [usually orange] and the TP signal wire [usually dark green and light green]. repeat the KOEO test. if the code 63 returns, check for 5 volts at the...
  8. D

    BBK Performance SSI Intake

    i didnt use a spacer between the two manifolds and still cant use the stock hood. i have a 4 inch cowl hood on for now but it wont pass inspection so im still going to have to buy another hood. plus my way works just as good as the spaceras fsr as clearance is concerned and alot less exspensive.
  9. D

    BBK Performance SSI Intake

    i tookthe fitting off the the pipes to napa and told them what i needed and they gave me an elbow to take its place, the i got a 3 feet section of 5/8 and a 3feet section of 3/4 heater hose and installed them from the fire wall to where they belonged. the temp sen. isnt installed but that can be...
  10. D

    BBK Performance SSI Intake

    if my wife did this right this is a picture of the nipple/elbow i used to reroute the heater hoses that seem to hold the upper intake up and gives so much clearance problems hope this helps.
  11. D

    BBK Performance SSI Intake

    thats what did durning the seconf install, start hard run as long as i gave it gas then die. timing was off a tooth. as for the stock fuel rails i'm not sure. car runs really good now.
  12. D

    GT vs SRT4 results

    theres a srt-4 running around here thats just sick!! i was with my boss one day at lunch time in his z06 when we rolled up on this blacked out srt-4 and only got him by about a car . the vett has run a 12.2 . but the srt is an ugly car i just dont ender estimate them or any othere car out there
  13. D

    BBK Performance SSI Intake

    maybe your timing is off by a tooth this happen to me durning the second install.if you press the two fuel rails together with some auto silicone on the o-rings they should slide together tightly with no problem and not leak i have no leaks at all on mine. the heater hose line is a little...
  14. D

    BBK Performance SSI Intake

    changed intake gaskets yesterday and found that one of the tabs on the head gasket got bent durning first install,thats where the vacuum leak came from, now car has more powere. what i dont understand is why the cam sounds more pronouced when all i changed was the gasket. sounds really good...
  15. D

    BBK Performance SSI Intake

    thanks i'll do that
  16. D

    How to clean the wheel wells....

    i work in a detail shop and we use an all purpose cleanerto spray the wheel wells with then after letting it to sit take a presure washer to them . once they are as clean as we can them we use a black trim paint to freshen them up to the best they can get. we do this on every thing from hondas...
  17. D

    BBK Performance SSI Intake

    I talked to a friend on mine today & he said the same thing that it sounds like a vaccuum leak. & i told him i've checked & rechecked everything. He told me to pull the plugs. If theres oil on any of the threads of the spark plugs then i have an internal vacuum leak. so i pulled the plugs...
  18. D

    BBK Performance SSI Intake

    right now the car has under drive pulleys, equal length tube shortys,off road h pipe,2.5" flow masters' cold air ,3.55 gears i was told by the guy i got it from it also has a b303 cam,msd 8.5 wires msd coil, auto lite plugs(need to be p graded) cobra r clutch,bbk quadrant,fire wall adjuster ,as...
  19. D

    BBK Performance SSI Intake

    This is the response from BBK ----Original Message----- From: [email protected] I recommend AFR 165 heads with the valve and spring upgrade package and a nice Comp Cam. That will give excellent low end and all around performance. I've tested the AFR 165's vs. the 185's, The...
  20. D

    BBK Performance SSI Intake

    even bbk is saying upgrade cam heads,ect.
Top Bottom
Back
Forums
Menu