Search results

Barry, A few photos would be nice. I have been waiting to see what you did on yours. That really stinks that you have to pull it to see what is going on with the oil pressure. Kinda frustrating but I guess it is the nature of the beast. :(

Hello all, Ok, here we go. My 78 KC has been sitting all winter. I started a few times to make sure I kept everything lubricated and working. Well it does run now BUT is misfiring (I believe) a bit. I let it warm up today to 180 degrees and took it for a spin. Unfortunately, it did not...

Real nice! Very clean looking II..

Thanks for the replies. I will keep you al posted on the actual ET's. I will run it on the factory skinnies and get the time. I will then run it on another set of tires and rims. What do you guys reccomend? I want to just buy another set of tires and rims that will "bolt in" and give me a decent...

The cam specs are as follows: Comp Cam Extreme Energy 274 intake, 286 exhaust, 519 intake, 523 exhaust. 110 degree lobe sep. Real nice throttle response and "popcorn popping" sound at idle. :)

I installed heddman headers with 40 series mufflers all 2 1/2". The tone is nice, I cant even hear Zepplin playing on the old original 8 track :) Rear end? Good question. It is stock (limited slip I believe and yeah I know it probably wont last long) For some reason, I am partial to the cute...

Ok, here is what I have, what do you thing the car will run? I will be runnin it this year @ Route 66 in Joliet Blueprinted machined 351w Block New Scat 9000 Series Cast Steel Crankshaft H-Beam Forged Steel connecting rods, ARP bolts SRP Power Forged 10.5 to 1 Flat Top Pistons J & E...

Hey Barry, How about some photos? Once I get this to work, I am ready to rock and roll!

I would absolutely love to lower mine but are very concerned with the clearances. Right now, the mufflers sit soo low that when I pass a stone, it "clinks" under the car. If there is a bump in the road I get scrapes. What are you guys doing differently? I dropped a 351W with aluminum...

Left side

Front left

Right side view

Here ya go, I hope the photos show up http://i291.photobucket.com/albums/ll298/vooderman/Car%20photos/P3060111.jpg

I bought a set of Headman headers for my 351W conversion. I hate it! :mad: The passenger side does run under the engine crossmember and the collector is too low. A bump in the road creates alot of noise and a few sparks from it scraping the ground. I do plan on replacing them soon but have not...

I had a similar problem. The header collector was directed at my trans crossmember. (drivers side) I removed the crossmember, cut that section of the member out and welded in a piece of 6" diameter pipe that I cut in half. I tig welded the pipe to the crossmember sections (where I removed the...

Thanks for the replies. It is a non A/C car. I'll give it a try this weekend.

I am going to replace just the hoses but it appears that the heater core needs to be removed to get at the hoses. Am I correct with this?

Well, I am a new poster here. It looks like there are some die hard II enthusiasts here and the wealth of information can certainly help me with my project. I Installed a 351W in my 78KC and man I can tell you, it had to be shoehorned in there but it now fits. (and actually runs) I am going to...

Ok, I would like to post some pictures of my 78 KC but cannot fuigure out how to. Can someone please help??