Search results

  1. C

    94-95 Edelbrock Throttle Body Adapter

    I have a Edelbrock throttle body adapter for sale on ebay. It has been ported and polished with the egr welded closed. I ground the Edelbrock name off and painted it black wrinke to match the rest of my engine. Please take a look...
  2. C

    how much horsepower?

    Where did you get the $600 quote from? Where I work would problably charge $1500. Thats with disassebly, valve job, portwork, clean up mill, setting the valve heights, and assembly. I could do the heads for around $900 depending on how much work is needed. Then for the intake it depends on what...
  3. C

    how much horsepower?

    As a professional head porter all I have to say is that if you go for the bigger heads or not they need to have work done to them. Heads out of the box have a tremendous amount of power left on the table and with a little work will run even better. As for if you are going to add a supercharger...
  4. C

    SN95 to fox throttle body swap?

    not too bad for most of it it is used! all the portwork and machining was done my self. i had to cut bigger and deeper reliefs in the stock pistons for the 2.02 -1.60 i used a flycutter that goes into the valve guides of the head so i could do it incar. im running on the edge for p to v. i...
  5. C

    SN95 to fox throttle body swap?

    At 5600 rpm running 4.882 volts At 5800 rpm running 4.937 volts Power still climbing at 5800
  6. C

    SN95 to fox throttle body swap?

    Ok thanks. im new on here and getting used to this site. i am running a n/a stock bottom end with 115k, comp 224-232 112* .600 lift, 10.2:1, ported performer rpms 2.02-1.60, ported carbed victor jr. converted to efi, ported 70mm tb, mac 1 3/4 shorty headers, offroad h, american thunder...
  7. C

    SN95 to fox throttle body swap?

    I swapped intakes on my 95 a little bit ago and i needed a sn95 throttle body adapter to run my setup. What would it take to switch to a fox body throttle body? aslo when i got my car tuned i am "pegging out" my pro-m bullet mass air flow sensor and was told to get a lightning mass airflow...
  8. C

    Ported E7's!!

    SOLD Have a set of ported and polished E7s for sale NOT SOME BACKYARD HACKJOB!!! Magnafluxed and pressure tested for no cracks or leaks No broken bolts or stripped threads 4 angle valve job on intake and radius on exhaust Uses Felpro 1250 intake gasket and 1415 exhaust Stock valve...
  9. C

    Titanium retainers for sale

    I have a set used titanium retainers for sale. They will lighten up your valvetrain and let your engine rev higher for more power. Fits 1.437-1.550 double or single spring sizes. 5/16 or 11/32 stem size 10 degree valve lock Email me for pics [email protected]
  10. C

    Titanium Retainers 4 Sale

    I have a set of used titanium retainers for sale. They will lighten up your valvetrain and let your engine rev higher for more power. Can be used with 1.437-1.550 spring size double or single 5/16 or 11/32 stem size 10 degree lock asking $100 email me at [email protected]