Search results

  1. R

    Car bucks violently back and forth

    Hello, My car has been bucking violently back and forth after I let off the gas. The car only bucks when I am only lightly on the gas or off it completely and it does not do it in all gears, although I forget which it does it in. The problem also goes away when I get back on the gas, but I...
  2. R

    Water Pump Question

    Hi guys, I recently noticed a lot of steam coming from behind the water pump pulley and decided to replace my water pump. The car seemed to be running very hot (my coolant temp gauge decided to go at the same time so I couldn't tell just how hot it was, however I was getting very little...
  3. R

    Water Pump Problem

    Hi guys, I'm having a water pump problem. I can't fully tell if I'm overheating because the gauge stopped working today as well, which is posted in another thread. When I came home from the gym today, I saw steam coming from my hood. Looking at the engine, I noticed a lot of steam coming...
  4. R

    Water Temp gauge Problem

    Hi guys, I'm having a weird problem with my water temp gauge. When driving, it does not move, stays at the very bottom of the gauge, no matter how far I drive. When I turn the car off and take the keys out, the temp slowly goes up to around what it should be, halfway up the gauge, if I drive...
  5. R

    No spark while cranking, spark after crank stops

    As the title indicates, my motor will not spark while the motor is being cranked, but it sparks once after the cranking stops. Is there some kind of sensor that controls this. I thought it would be the crank sensor, but after checking the Haynes repair manual, there is no crank sensor...
  6. R

    Code 19 Question

    I have trouble code 19 on my car. I checked the relay to the fuel injectors and it's good, over 12 volts. The next thing I was told to do was check pins 37 and 57, where are these pins. If they are on the computer how do I tell which ones I should check because when I overhauled the computer...
  7. R

    Codes Question

    I got code 11 (system pass), when I pulled codes yesterday. However, I also got a few other codes, TPS out of range, Idle too high, duel pump relay system, etc. What does this mean? Are these things bad or does the code 11 supercede them? The other codes I got were 53 (Throttle position...
  8. R

    GT40P Compression Question

    I've been comparing gt40 and gt40p heads. I'm pretty much going to grab whichever one I can from my local junkyard, understanding I'll need new headers for the GT40P. I'll probably get the GT40P, because they make more power, but my question is, I know the lower combustion chamber will...
  9. R

    Clunk after putting car in gear

    I get a clunk under acceleration right after I shift into gear sometimes. I felt the driveshaft to check the u joints and the driveshaft had some play in it. I then replaced both u joints and the play was gone. I drove it again today and I was getting the same problem, again not every shift...
  10. R

    Coolant Temp Sensor

    Hi guys, I'm not getting a coolant temp reading on my gauge. The computer one seems fine though, because it didn't come up in the engine codes, but the gauge one's bad. It looks like someone put an extra nut on it and for that reason, the lead on the wire isn't making a good connection to the...
  11. R

    Igniton timing

    I looked online for this and surprsingly couldn't find it. I just need the ignition timing on a 1992 Mustang 5.0 HO, I don't have a VECI label on my car, so if someone could just look on theirs. Thanks.
  12. R

    Check Engine Light

    The check engine light in my 1992 mustang comes on whenever I go over 2000 rpms, but as soon as I go under that it goes off. Any ideas?