Search results

  1. heetseeker91

    CI Swap on '91 GT

    Ok, so i'm gonna sound like a noob here (Cuz i am so heckle if you will) but what would supporting mods be? larger Mass air and injectors? bigger fuel pump? timing advance? to give you an idea this car was a bone stock california car until the gasket blew. from top to bottom. so i'm just making...
  2. heetseeker91

    CI Swap on '91 GT

    great thanks for the info! eventually after i get the Mustang fund back up i plan to build another block with a twin turbo setup in mind :D
  3. heetseeker91

    CI Swap on '91 GT

    nice. I also forgot to add that i want to throw in some 3.73 gears as well, but wanna get the engine fixed so i can at least drive it before it gets too cold or the snow season starts.
  4. heetseeker91

    CI Swap on '91 GT

    Hey everbody, I'm currently in the middle of a project and was curious what i have to look forward to when its completed. I have a '91 Mustang GT that was bone stock except for the CAI and flowmasters. anyhoo. I had blown a head gasket and was in the middle of replacing it and got a wild hair...
  5. heetseeker91

    Blown Head Gasket

    thats the best news i've heard all day lol, i willl gladly swap a motor rebuild for a weekend, a head gasket, and a case of beer anyday thanks for the info
  6. heetseeker91

    Blown Head Gasket

    I posted a thread on here about a month ago about some weak compression in cylinders in a '91 mustang gt. I have now ran my own compression check and found that the two weak cylinders are side by side. #1 and #2. So my question is, is it possible for a head gasket to blow between the two...
  7. heetseeker91

    gt40p heads

    Thanks for all the replies guys the reason i was asking was because i found a deal on a set of remanufatured gt40p heads for super cheap so maybe i'll just buy them and when i can afford an intake purchase that and install it all at once...:nice:
  8. heetseeker91

    gt40p heads

    so it would be a direct bolt-on upgrade with no modification needed? sorry... dumb question but i'm a mustang noob....
  9. heetseeker91

    gt40p heads

    Can these heads be used on a stock 302 intake? well, at least until i can buy a better intake?
  10. heetseeker91

    '91 GT weak cylinders

    yes, the car ran fine until i added the oil and the coolant. As far as what the compression acutally was i do not know because they didn't tell me. there is 118,000 miles on the engine. The previous owner, my uncle, did tell me that about 3 yrs ago it did overheat because of the water pump...
  11. heetseeker91

    '91 GT weak cylinders

    Thanks for all the replies. To be honest a head gasket swap is pretty intimidating, however i dont think i can make it run any worse haha. I think i will try that on my next days off. since i was low on oil and coolant that might be the best way to go. if anything it would tell me if the bottom...
  12. heetseeker91

    '91 GT weak cylinders

    :bang:Ok i'm about ready to pull my hair out so i figured i would get some advice from my fellow mustang owners. I will first off admit that i am a mustang noob so i don't know much about what too look for. I have a '91 GT that aside from a cold air intake and exaust, it is stock. A few days...
  13. heetseeker91

    Engine running rough at start-up

    Ok i'm new to this forum and i am needing some advice on what to do with my car. :mad: I have a '91 GT that i have had since 32,000 miles and a couple weeks ago i was driving and had the stereo blaring and wasn't paying attention to my temp gauge (the water pump went out) well, it got so hot...
Top Bottom
Back
Forums
Menu