Search results

Cool thanks for the info. I would register over on turboford but they won't accept my yahoo email address.:(

I see that he used a motor plate to mount his. I'll have to do more research to see if standard 2.3 foxbody Mounts fit the 94-95 k-member.

Thanks for the info I'll check out the link!

Let me preface this by saying im not planning this but merely asking for my own knowledge and curiosity. Can an 87-88 TC motor be bolted in the 94-95 cars? Would the wiring work be the same as in a foxbody(re-pinning and whatnot)? I would assume it would be very similar but you know what they...

Anyone have more info on this car? Suspension setup? How much is it lowered? What motor/trans is he runnin? My favorite so far, simple, and clean!

Are you saying I should use the 2.3 NA engine bay harness, or dash harness? So I'd need form the junkyard: 1. EFI 2.3 engine bay harness 2. EFI Fuel tank from NA 2.3 3. EFI Fuel lines from NA 2.3 4. EFI Fuel pump harness What else? I did notice my car actually has the grommet in the...

The turbocoupe is very rough as far as the body goes. Both quarters, doors, trunk lid, and lower front fenders are rusted badly. The hood is good, along with the front grille and bumper which will be going on my daily driven v-6 bird. The seats and console will be going into the stang, and...

I did some research over on turbo ford, apparently there should have been a computer behind the passenger kick panel, but I pulled it and there is nothing there. So I guess that means I have to swap dash harnesses?

First off, I am not new to this site. I had to create a new account, my old one wasn't letting me post anything. Ok, I have a complete 88' turbo coupe and a roller 1983 mustang. The mustang was originally a v6 auto car, which now has no motor or trans. I plan to swap in the 2.3t and 5spd, but I...