Search results

  1. W

    Cranks But No Start ... But Runs When Started

    Installed the new fuel pump assembly today; first time key on it ran about 2 seconds ... filled 2 gallons of fuel, again key on, 2 seconds, cranked for just a moment and the engine started immediately and actually sounded more 'energetic' than lately before what now I know was a pump failure...
  2. W

    Cranks But No Start ... But Runs When Started

    Thank you very much for the reply ! Thought I would get a message is case of a reply but did not, just noticed your friendly advice ... By now I have extracted the fuel pump and it does not work (direct connect to 12 V no function); have heard that it is not possible that the engine could run...
  3. W

    Cranks But No Start ... But Runs When Started

    I guess the problem I am having is fuel pump related ... checked all the basics, but do not hear the pump run when I turn the key to ON. I can crank, the engine will NOT start; if I use starter spray, it will start and run just fine. There is some circuit that controls the fuel pump status when...
  4. W

    MACH 1000

    Suspicious post, therefore deleted.
  5. W

    About Spare Parts

    Thanks VitoGT, impressive inventory, found all I wanted ... only problem is they ship from different locations, so if you order front and rear brake pads and one air filter you pay three shipments that jack up shipment cost up to more than $170.00 ... hope to find an alternative before the need...
  6. W

    About Spare Parts

    Write this note from Germany ... own a 4,6 built 2003 and need basic spare parts that I can not find in this country. Anybody has a hint as to where I can order parts from a vendor that ships abroad? Any hint is welcome, I can probably arrange shipment (I guess) through friends back in the US in...
  7. W

    High Idle - anyone...? WMBurns??

    real novice's question Just have my 1st stang as of yesterday, idle is high at times, have not yet re-trained it ... wanted to first basically check the IAC (voltage and verify shut-off when disconnected) and (it is painfull, I know) wanted to make sure this is the right disconnect: (hope at...