Search results

  1. C

    Used Centerforce Clutch for 10.5" clutches out of a 94 GT

    Centerforce clutch in good shape for sale. I cannot throw it away, but need it out of the garage. Make an offer...
  2. C

    Factory 94 GT driveshaft for sale

    I have a factory 94 driveshaft along with the factory ujoints and yokes. The ujoints appear to have no slack in them. I would take 50 +plus shipping.
  3. C

    94 GT T5 / Bellhousing

    I have a T5 and bell housing out of a 94-95 Mustang GT 5.0l fs. It has about 90000 miles on it but is in working condition. It needs a rebuild.... I would like to get 200 for the tranny and 75 for the bell housing. I have it in a tranny pallet, but would prefer a local sale. Buyer to pay any...
  4. C

    87-93 Valve covers for sale

    I have a set of 87-93 valve covers that I used on my SN95 up until recently. They are powdercoated red in ok shape. There are a couple scratches in the PC. The internal baffles have been ground out and removed. $50 obo
  5. C

    New Red Anodized UPR Timing pointer

    I have a red anodized UPR timing pointer for sale. I was going to install it, but then i realized that the R4 block bolts are too big for it to work and then I switched to the explorer crank sensor setup which replaced it altogether. Literally opened up the packaging threw it away and then...
  6. C

    92MM Pro-M MAF with 50Lb Calibration FS

    I have a Pro-M 92MM MAF with 50LB calibration and 30 pt plot for sale. In the pic you can see that there is a peice of plastic missing on the plastic on the connector. It's just a superficial crack there is no damage to the unit otherwise and it works great. The clip will still fasten to the...
  7. C

    3" Pro-M Blow Thru MAF 80LB Cal - New

    I have a brand new 3" Pro-M MAF with a 80Lb calibration with a 30Pt Plot. This was bought in november and was never used or plugged in and Pro-M wont accept a return. My loss is your gain. I am in this 425$. Will sell for 275 obo.
  8. C

    FMS 30Lb Injectors FS

    Fresh rebuild including orings and pintle caps. $75 obo
  9. C

    94-95 FMS Cobra Upper intake and 75MM TB

    I have a 94-95 Cobra upper intake with a 75MM Polished Pro Products TB. The intake has been sanded smooth and powder coated red with a PPI cobra intake plaque applied. The EGR ear was cut down to clear 87-93 valve covers and the EGR port was tapped and capped so no EGR will be required. The...
  10. C

    19-49 Vortech YS Trim For Sale

    Vortech ys-trim headunit, satin, straight discharge comes with a 2.95 8-rib reichard pulley, aluminum tensioner pulley, new tensioner plate. Also includes a curved discharge and a 8 Rib 7.5" Crank pulley. The pulley combo is said to make roughly 18-20psi boost. Also included are low...