Search results

How do you wire this up. Does it get wired to the ecm or is it just key on power and ground Instructions suck. If it goes to ecu what pins does it land on

So do I just cut the flange off so it fits in my bbk cold air intake where the stock one is

So I’m installing cobra pbr duel piston breaks on my fox with sn95 spindles I got hawk HB111b.610 lads and centric 227.61044 rotors My problem is they won’t fit pads seem to be to thick Piston is in as far as it will go old rotors won’t work with pads either Any suggestions on what to do

Was wondering if this blue print motor would work good with a on3 turbo kit Specifications Brand: BluePrint Engines Part Number: BP3313CTF 375 HP / 405 FT LBS 9.5:1 Compression Ratio Block Hand picked seasoned block Square and parallel decked Align honed main bearing bore Cylinders honed on...

OK I have a 87 5.0 and 2 engines what one should I put in her. I have a 460 bb. 30 over or a 347 built . upwhat way should I go. Help me out.

can you send me links to where i can get stuff for the conversion and i want to keep it efi. thanks

Just did a under drive pulley swop and now my battery wont charge what do you think it is I have to drive it to work tomorrow.

How hardest to swap out the automatic transmission in my 89 mustang

Does anyone know where to find a video on how to install a convertible top for free on 89 mustang convertible

Today when I got on it. It took a while to kick in what do you think the problem can be. I hear a metal clanking when I went off of it. This is a automatic transmission.

well im about to buy this mustang and he told me it has trick flow heads. How do i tell if he is right or wrong they look like stock. How can i tell.

i was looking at getting these things from mustang unlimited in a month. will this be a good set up. Afr 1420 heads xtreme energy hydraulic cam cc3518 PRO MAGNUM ROLLER LIFTER RETROFIT cc8931 TIMING SET HI-TECH DOUBLE ROLLER cc3138 ROLLER ROCKER SET ULTRA PRO 3/8" 1.6 cc1631 you think...

i seen this post a while back and can't find it 95 steering wheel in a 87. just wondering if anyone knows where its at was thinking of changing it out. just looking for the how too.

what makes a cobra a cobra engine

is the bolt pattern the same or will i have to change some stuff. its only 500 more cor me to go the 408 route then the 347 just hope that all my stuff ff fhe 302 fit.

whered the best place to buy a long block 427

ok my car was fine before the conversion. Took it in and they had it for 3 days now they called me and said i need a new rack and pin. He said its all bent. Could he of did it in the aligment. What tack and pin do i need for a 87 using 95 spindles and its power.

got a new tach but through out the instructions what wires do i splice any one got pics thanks

:nice:where could i get a good ford flag for my fords. i live by all bow ties. want to show off my blue oval

ok now i went through 3 bellhousings (from over torking starter bolts) 2 flywheels and 2 starters. Today i tried to start her up and again grind grind on the flywheel check tork 35lbs tight should be good but no. All new stuff. took starter out looked at flywheel some teeth not so good now...