Search results

Got her back in! Thanks creektrack for the suggestion on raising the motor slightly to improve the angle, My jack didn't quite reach the oil pan so i just pushed up on it myself with one arm while moving the transmission with the other and BOOM, it was in. And Rusty, I think the T-45 has a...

Thanks for the input guys. I noticed that when placing the long bolts through through each boss around the bellhousing that the shoulder of these bolts is exposed on the other side no matter which position I try, even the top. I'm thinking that these long bolts belong in the positions that have...

Hey guys, its been a while since I've been on this forum but I could use some input! I am in the middle of replacing my clutch and while initially I had arranged all of the bolts from the bell-housing to the block I managed to kick several objects around while removing my pilot bearing...

No recent changes to the exterior so here's a pic of my Hurst setup :)

Ok thanks for the info!

Hey guys, it looks like I will need to replace my clutch this summer so I have been reading up on different clutches and reviews by members in older forum posts. I have a 99 GT with a T45 and was wondering if anyone knows the spline count and outside diameter for this model year and...

Are there any LT manufacturers that have addressed this issue? Or do they all pretty much interfere with the transmission removal?

SWEET :D

11 psi on stock internals? or do you have forged?

My front O2 sensors were further down on the new midpipe and the rear O2 sensors were further forward, I didn't have to make extensions for the rear sensors though, I just moved them out of their factory bracket. I'm not sure if the same will be required for you and the prochamber but in the...

I've been running Bridgestone Potenze RE960AS tires for a while now and love them! I live in the seattle area so I needed a tire that would hold up well in the rain. These do great on both wet and dry pavement Bridgestone Potenza RE960AS Pole Position

+1, the install isn't very hard but a buddy of mine installed steeda cc plates and screwed up the drill holes, the allignment shop had to drill new ones for him As far as the H-Pipe goes, I imagine the MAC unit will be better/easier to install than the JEGS piece I bought. One thing I had to...

Well seeing as its a dealership I'd try to get them to go as low as possible, I wouldn't want to do that if it was a private party but I wouldn't feel as bad with a car salesman. I used to work at a dealership and more times than not they were willing to drop the sticker price quite a bit to...

>6500 sounds VERY rev happy (and way too much fun :D), is it possible to build the top end on a 2V using the TFS intake and a nice set of heads & cams such that it flows enough to Tach out like a stock 4V?

Agreed! I was working at a Carquest store at the time and bought the tool for extra cheap, it kept slipping when I used it so I resorted to some needle nose pliers and had much better luck!

Fat chicks are like mopeds. They're fun to ride until your friends catch you on one. :D

This is a good point, I was under the impression you had already tried using the autozone tool. The rear caliper pistons have to be turned in order to be compressed, the autozone adapter hooks up to a ratchet so you can rotate the piston. I tried using the tool with no luck and thats why I...

I had the same issue on my GT when I was replacing the pads a while back. Usually means the caliper is shot or needs a rebuild, I ended up buying a replacement unit.

Fastest car EVAR I snapped a pic of this thing on my way to nevada a few years back

At least the work is slightly clean. I'm not saying I like it, its butt ugly but I've seen much worse