Search results

Hello fellas I want my stock rpm in my cluster to work again. I did a carb swap and would like my bbk cluster to work like it was. I have gone and spliced into the green and yellow wire behind my cluster #11 and ran it to my negative side in the coil and on my msd box tach signal hook up and...

l

?#1 WHAT INTAKE SHOULD I USE??..I HAVE PROCOMP DUAL PLAIN LOWER INTAKE AND A IMITATION LOWER INTAKE VICTOR JR. ?#2 WHICH ROCKERS SHOULD I USE.. 1.6 OR 1.7 ITS MY DRAG CAR SO LOOKING FOR THE BEST SETUP ON THE TRACK! RUNNING A E303 COMP CAMP WITH 373 GEARS WITH 5 SPEED TRANNY..CARBED MOTOR...

OK FELLAWS IM RUN NITROUS ON MY CARB SETUP. HERES THE CATCH THOE IT WAS ORIGINALY EFI SWAP TO A CARB RUNNING A REGULATOR ON A STOCK INTANK FUEL PUMP. I KNOW THATS THE GUETTO WAY TO GO FUEL WISE BUT WERE DO I GET MY FUEL FOR MY WET KIT

Ok guys just a quick question here me and my buddy both have 88 mustang 5.0. His is fuel injected mine is car we both have e303 cams he has a lopy idle realy nice mine is quit it only sounds lopy when its cold when it warms up u cant even tell i have one my cam is advanced 4 degrees and i have...

Ok fellas i wondering how high i can rev my setup. My setup consists of procomp dual plane intake (1500-6500) holley 600 carb e303 cam longtubes (fullexhaust) alumenum pullies 373 gears alumenu d-shaft gt40p heads (afr springs) 1.7 rockers msd 6al2 msd wires and about 30 Degres of timing

I just bought a 6al2 ignition box for my carb 302 mustang.Im having installation isues i have the intructions but dont quite get them i have follow the diagram but its not working.Heres what i got done heavy red is connected to positive on the starter solenoid heavy black to negative on starter...

ok guys i just purchased a simi build 306 mustang gt the mods are fully build botom end stock heads ported x cam 1.7 rockers edelbrok uper and lower bbk spacer and trottle body cnl 76mm cal for 24 injectors the isue is this think pops like cracy out of the cold air intake timing is set at 10...

Okay guys like the titlle says i did a compresion test on the car beacause i found oil or gas on the treads the results were. cylinder1 60 cylinder2 60 cylinder3 70 cylinder4 70 cylinder5 60 cylinder6 70 cylinder7 70 cylinder8 75 now the car runs great no overheating oil presure looks good...

Okay guys i fix the isue with my carb got it to idle just were i whant to and i think i set the idle screws just right. when i did my carb conversion i kept the stock efi fuel pump and just ran a carb fuel regulator.Well know the reg is not being very accurate it reads like 9 psi one day the...

ok guys ones again asking the pros Im looking to buy a new carb since my is not working right. i have my mind set on a 600 holley double pumper. im not very familiar with carb setups as i just recently swap from efi to carb my question is i have a 302 Dual Plane Aluminum Intake that makes its...

Helow there just resently did a carb swap on my 88 mustang 5.0 im using a 255 fuel pump with a holley return regulator but the fuel presure dosent go down do u guys think is 255 is to much and i should just put the stock one back on there.plz let me know or what could couse that the fuel gauge...

i just swaped to carb i need to know how to wire it as thats all i need i need 2 know were the ignition box connects to the dizzy and the coil if u have pitures that would be asome plz guys im a bigener detail info plz

hellow there one again after dealing with sensor here sensor there i said f**k it were going carb please excuse my french what im here to ask know is that im going to use the 255 intank fuel pump with a fuel reg but which one guys another thing im going with a edelbrock perfomance manefold and...

okay guys im the end of the road after loveing this car im at the point were i whant to sell. The isue im having with it is iradikal idleling when i try to time it timing mark moves back and fourth dosent stay in one place so i can get a acurate seting. When i get it to drive with out staling it...

hi there one again guys im having a problem with my plugs.they seem 2 be faulin out and im forse 2 get new ones every tree weeks or so. im gaping them at 54. fuel is there timing is at stock 10.The mods that i have are alumenum pullys no smog what so ever intake,fuel reg,uper and lower...

Hellow there i have a 88 stang lx. It had a issue not to long ago where it would hesitate and pop and wouldent whant 2 go over 3k.I try everything till i put new plugs it ran great and smoth by the way there motocraft.So the other day took the stang out and it stared with its spudering and...

Hi there I whant to know what other part can I do to make my sd 88 stang faster. I already have alumenum pullys intake uper and lower intake 70m trottle body and spacer headers hpipe full exhaust 373 gears 255fp a fuel preside regulator msd wires cap and coil alumenum raydiator short shifter...

hi there i recentyly put a 255 fuel pump on my 88 mustang 5.0 after the install whent 4 a ride and the car stared sputering and poping at full trottle if i only go half way the car runs just fine its only when i flor it all the way down it does its thing i have my fuel presure set at 39psi...