Search results

  1. S

    Rebuilding a 4.6 compared to a 5.0

    I have rebuilt a few 5.0's in my day of mustangs, and have done a good job (I think). My question is, the 98 GT I own now, the motor is getting up in miles (147k). My fear is one day soon I will be getting her towed home. What is the difference, if any when rebuilding the different motors? How...
  2. S

    98 GT Offroad H-Pipe NJ

    PM sent...
  3. S

    TPS Sensors in wheels

    Do the 05 v6's have the sensors in the wheels to measure the tire pressure? Im looking to trade my wheels to someone who wants the sensors, and I do not kn ow If i have them or not. Is there a way to check without breaking the tire bead and looking? these wheels are on my 98 GT so I...
  4. S

    GT to LX tail light swap

    You need to take out the rear plastic panels to access the lights as if you were to change a bulb, then its just a matter of a couple of nuts on the back of each light assembly to remove and install LX one. It should be quick and easy replacement. Bulb housings should fit.
  5. S

    1991 5.0 missing when hot

    well i'm pretty sure I'm having the same problem the OP is. I'm not jacking anyones thread. Why should I start ANOTHER thread for the SAME thing. :shrug: I'm sorry for inquiring as another fellow mustang owner. I'm not trying to start any crap, nor do I want to recieve it. Now if anyone else...
  6. S

    Starter question again

    Same thing happened to me. I found that I kept getting crap sileniods from Avanced Auto Parts. The first one i replaced, only clicked. I replaced that one and the next actually stuck on, and the only way to fix it was unhook the battery. Finally, I took my happy butt up to Ford and got a...
  7. S

    1991 5.0 missing when hot

    What exactly do you mean by a high speed miss? Mine sputters at 4k at WOT, once at 5k its stops.
  8. S

    16 inch pony wheels

    email sent
  9. S

    Rear control arm bushing install question

    well unfortunately trying to stay on somewhat of a budget here, since you now, christmas just ended. I found a set of poly urethane bushings for $75 on MustangsUnlimted.com. Dont think I can afford a set of new control arms, so I'm stuck with this for a while at least.
  10. S

    Rear control arm bushing install question

    I have a lot of play in my control arms, enough that I get a popping sound when I take off from a stop, and rear end noticably moves when you rock the car side to side or forward to back. I am ordering new bushings for the rear lower and upper control arms just to cover all basis back there. I...
  11. S

    Torque spec on front rotor/ bearing nut?

    I am replacing my front rotors and pads on my 91 GT. I have everything done except for tightening the nut that hold everything together. I have searched high and low, in and out of the chilton manual, and haven't found how tight to tighten the nut.
  12. S

    Can you test a fuel guage????

    Troubleshooting the gauge and sender circuit: Since the sender uses a variable resistor, sum the resistor values of 22 Ohms (empty value) & 145 Ohms (full value). That gets you 167, which you divide by 2: that gets you 83.5. So in theory, 83.5 ohms is 1/2 full. A trip to Radio Shack for the...
  13. S

    SPEEDOMETER NEEDLE JUMPING AROUND

    Well I'm sorry to say, but glad that I am not the only one with this problem. Needle bouncing around every where. Loobed (:rolleyes:) my cable, checked the geers, and still bouncin up to 40 mph. Took out the cluster and spun the unit on the cluster and started bouncin. Looks like it is tie to...
  14. S

    Car dies when turning right EVERYTIME!

    I'm sorry, dumb question? Baffle in the gas tank? what is its purpose?
  15. S

    How to fix the "Jumping Speedo"?

    Thanks for the info! sounds pretty easy enough.
  16. S

    How to fix the "Jumping Speedo"?

    Well sorry guys, but here is another post. I am slowly but surely fixing all the little kinks... SOOO, as I accelerate from 0 to 30mph, my speedo jumps around wildly, and then settles down and acts normally any speed after 30. Clues? Parts? jrichker.... I know you got somethin for me. You...
  17. S

    Official Thread of Applicable Junkyard parts for Foxes

    would this be mustang seats are interchangable through those years???
  18. S

    Can you test a fuel guage????

    My 91 gt's fuel guage is not working. I recently had issues with the fuel pump not priming (fixed by the way), so in return the pump and sending unit were replaced. but the guage still doesnt work. I am curious if there is a way to test the guage its self, or is there something else to check...
  19. S

    Fuel pump not priming????????

    Black and purple wire in the top left of diagram. No I havent tried that. But I will.