Search results

computer Hey I'm looking for a good computer/EEC for a manual trans (DA1). Do you have one and for how much? I'm also in Cleveland, Oh. Thanks Jeff

Well, after doing more point to point & resistance checking on my wiring and voltage comparisons and even tried the test light procedure to see if my computer failed and it was. Well, not entirely not the circuit for the fuel pump. I had a local Mustang guy tell me just pull your EEC and try my...

I'll do some more reading. I'll pick through wiring again tomorrow morning then I'll report back. Thanks again, Jeff

Well I jump the pin 22 to ground and the pump runs. I also checked the wiring (pin 22) from my relay coil back to the EEC/60 pin connector and it tested out OK with my digital multi meter. Also all the grounds tested fine as well like pins 40, 60, and 20. So my EEC should be well grounded...

Fuel pump relay will not turn on Ok.... here is were I stand at the moment and may or may not have to do with pin 30 or 46??? It's all wired and I wanted to put power to the system to make sure the old Bronco wiring still worked and the 86' Mustang computer and harness wired into the new...

No... thanks for the detailed explanation. I need all the help I can get!! lol Ok well, hear is core of my problem I'm gutted a 86 Mustang and I'm installed the motor and harness into a 72 Bronco. So my Bronco does not have a clutch switch that I could tie pin 30 and 46 together. As I'm...

Just so, I understand you right. If I was running an auto trans I would have to take pin 30 to the "start" on the ignition switch and leave pin 46 un-tied to pin 30? But if I would run a manual trans pin can't have "start" voltage but should have 30 and 46 tied together when the clutch...

I'm not sure if it matters but I have a 86' "Speed Density" 5.0 not a Mass Air with a VJ1 EEC. So does effect the notion of hooking pin 46 up to the "start" like for a A9L? When looking at the Veryuseful's EEC diagram of the 86' Mustang it does not show pin 46 going anywhere to pin 30. Is the...

Hi, I'm need of a little help on figuring what to do with wire pin 30 and 46 on the EEC of my manual 86'. What isn't clear to me: pin 30 power comes from the ignition switch but is it only powered in "start" or does it always have battery power on it? Also I know pin 46 hits a bunch of...