Search results

  1. S

    Headlight Upgrade for 2011 Stang

    Wondering if anyone has found a good upgrade route for the stock headlights on a base 2011 Mustang? Recently got a Jeep Cherokee and the headlights are AWESOME and make the Stang's headlights seem like half the light.... Anyone?
  2. S

    Floor Jack Adaptors?

    SO, what floor jack adaptors are youfolks using ? Have a 2011 and am tired of breaking out the jack from the trunk to use on the side pinch weld lift points. I have seen rubber ones for $10 and up, and very expensive ones for $60 each. Dont want to risk safety to save a buck, but good...
  3. S

    Grease Leaking From Front Hubs

    We bought it new, hubs have never been off. Probably nothing to worry about....... Plus of grease does get on the rotor surface it will keep brake squeaking down, right? LOL
  4. S

    Grease Leaking From Front Hubs

    Doing a brake job on our 2011 V6 Stang.......found that there is grease leaking from both front hubs, onto the centers of the rotors. Diddint seem to be actually contaminating the brake surfaces yet but .....is this common ? Is there a seal inside the caps or something?
  5. S

    Blend Door Actuator

    Yeah, you just pull the glovebox down and then you can access two of the three relatively easily.....put your finger on it and have someone work the controls etc or disconnect wiring from one and test, etc........cant tell just by listening.. If you are blessed, it will be one of the two lower...
  6. S

    Does A 2011 V6 Have A Tps?

    Hi all - Hope someone can clue me in. Our '11 v6 stang went into limp mode twice and threw the P2111 code....."throttle valve stuck open"..... Doing a quick google search, seemed to indicate either a TPS or a throttle body replacement. Seeing as the TPS was cheaper, went that route thru Rock...
  7. S

    Blend Door Actuator

    Thanks BlackBuggy -- Yeah, I had figured it out. Man , its not impossible but what a pain. LOL. I ordered the part from Rock Auto and gave the Dorman part (#604-262) a try ....$10 plus shipping-- but found that the part does not fit as they redesigned the case a bit...slightly wider in...
  8. S

    Blend Door Actuator

    Did you have to remove the air bag module to get to that? We have a similar noise, happens when you switch from defrost& floor to panel vents....only then. Seems like the noise comes from up high in the dash.......
  9. S

    Electrical Ac Actuator Motor And Air Bag Module Removal

    So my wife's 2011 Stang just went out of warranty 6 days ago. Yesterday morning, she started hearing a loud clicking noise in the dash. Going by what I have found on google etc, it appears that one of three actuators in the AC system are bad. I sat in the car last nigt playing with the...
  10. S

    Car Was Hit.....opinions?

    Its more the question about the aftermarket parts and paint matching......I do plan on checking out other shops, though I really dont know of any "high end" shops, from experience. The one shop we would have considered is actually also the one that the other insurance company wants to use...and...
  11. S

    Car Was Hit.....opinions?

    So some woman rear-ended my wife in her 2011 Stang....blaze yellow pearl paint. Damaged the rear bumper and the black rear fascia under the bumper. Have been to two places so far....the dealerr and the bodyshop that the insurance company of the person who hit her wants us to use. Both...
  12. S

    Drivetrain New Gears Or Engine Bolt-ons?

    If you are looking for more grin factor, the gear change is the surest way that you may feel. I say may because going from a 3.31 to 3.73 is not that big a jump. If you do decide to go this route, IMHO you should have a shop install...setting up gears is not hard if you have the tools and...
  13. S

    Problem with American Muscle hood struts!!!!

    They got back to me via email a little bit ago and asked me to call. Did so and I ordered a new set. They say that the problem has been rectified...will post my results here once I get them.
  14. S

    Problem with American Muscle hood struts!!!!

    Chris Rose or Chris Young -- It has been a while now -- wondering if the brackets have been completed and if the yactually work on the 2011??
  15. S

    need a jack and spare...

    Just wanted to update here. No updates or word from Natasha, I guess this topic is more a nuisance for Ford than anything. STILL nothing , apparently, from Ford on this. Kind of sad IMHO. I just bought a new Ram 1500 Pickup to replace my aging SUV and guess what? Jack and tools under the...
  16. S

    Problem with American Muscle hood struts!!!!

    Chris from American Muscle -- can you tell me if the brackets are being "painted" or if they are being powdercoated? Can you send me a picture of the new mounts?
  17. S

    Problem with American Muscle hood struts!!!!

    How do you know they are US made? (The site doesnt show them as being made in the US) I do like the punched-hole look......do you have any pics of them installed on your 2011-up? Reason I ask is that they have the application for them fitting 2008-2011...... want to see how the brackets...
  18. S

    Problem with American Muscle hood struts!!!!

    Well, its not like this is a critcal part -- they didnt hang me out to dry, actually....they refunded my original purchase once I sent the other struts (all 3 shipments) back. They advised me that the new brackets areexpected in at the end of February but then have to be painted. They said...
  19. S

    Problem with American Muscle hood struts!!!!

    Hi...are the new brackets ready to ship??
  20. S

    3.7L Motor Issues - Been in the shop for a week

    Wondering how this turned out?
Top Bottom
Back
Forums
Menu