Search results

I need some help - I have the new hinges, but can't see how to get the inside nut on the upper hinge. I have removed the side panel by the drivers door and getting to the lower hinge should not be an issue (albeit there is a couple of electrical connectors that need to be moved out of the way)...

long tube headers, sct 4-bank, but did not have them delete cat codes (car has cats)....the codes say the car is running rich and lean (I think) - weird, if so. I have mil eliminators and did a search - this code does not seem to be common - though the new web site and search capabilities I'm...

got a 94 cobra, lowered about 2 inches and considering getting a diff cover that will preload the diff bearings - looking at LPW (preferred), as well as FRPP and Drake. my main concern is clearance - looking at the spacing between stock cover and the area that the spare sits in, I'm not sure if...

Need to replace water pump - diligently search for all the stuff I need: 1) buy water pump bolt set and timing cover bolt set from totallystainless - they were backlogged on the stud kit, so I buy the stud kit from Autozone - cheap - kit #23744 (Dorman). 2) I try to find pics of the...

replaced head gaskets (had to remove one head to get broken bolt from lower intake manifold, so did both heads). When removing the rocker arms, I noticed on of the pedestals had some fairly significant cracks. I then checked the one next to it and some cracks, but not nearly as large/long...

offset on fronts are 20mm - 9.5" backs are 24mm - 10.5" wheels are ADR M-classics - looked great on the '94, but not sure if the offset will work on a 2010 - buddy wants to buy'em - will they fit??

1994 cobra - removing cylinder head to get one @%$#%$^ bolt that is rusted in the head (front bolt, drivers side - rusted in and broke off cobalt bit in the hole, so head come off to get that bolt hole taken care of). Never been inside a 302, so I have some basic questions: 1) do I need to...

what's the stock silver color on 98 cobra wheels? I presume it's paint and not powder, but wanted to ask.....getting wheels powdercoated this coming week and they asked what finish was on the wheels now (if it's powder, it has to be chemically stripped, so adds cost...) Thanks! TomC3

I did the requisite searches, but could not find much on how to do this. Info is confusing - I plan on replacing both upper/lower do to "droopy doors"(vs drawers::rolleyes:) This is a '94 cobra. I'm reasonably mechanically inclined. 1) do I need to remove the fender? If so, how easy is...

Just bought a '94 cobra....harmonic balancer has been replaced recently by previous owner. I was trying to install a new distributor and following how-to: 1) I pulled #1 plug and cranked in a clockwise direction on the balancer bolt 2) when I felt compression in cyl 1, I watched the dist...