Search results

  1. ford_thoroughbred

    5.0 gt40p top end and tfs stage 2 cam

    found a 5.0 w the gt40p heads and intake bbk headers along with the tfs stage 2 cam.... is this worth investing money into????
  2. ford_thoroughbred

    fox coupe with a sunroof

    any body has a picture of a coupe w a sunroof? if so can you put it up and give opinions on one... i really want to put one in my coupe but not sure how it would look... i've seen them on the hatches and they look pretty good. I've been wanting a car with a sunroof for a while and i kind of want...
  3. ford_thoroughbred

    2000 Explorer 5.0 block vs. other 5.0 blocks

    thanks for all the replies
  4. ford_thoroughbred

    2000 Explorer 5.0 block vs. other 5.0 blocks

    found a 5.0 block out of a 00 or 01 explorer and was wondering was there any advantages and disadvantages in this block compared to other 302 blocks or are they basically the same
  5. ford_thoroughbred

    88 T Bird help

    I was looking into getting the explorer cam with the intake and injectors. Looked at some numbers and the lifts on the cams (ho and explorer) were kind of close. The explorer cam had a little more lift than the ho.. But was considering the 40p's due to the fact that I was getting a whole top end...
  6. ford_thoroughbred

    88 T Bird help

    all i have to do is add wires to pins # 50, 9,. the power and ground for the maf run to existing pins... move pin #11 to 32 and pin# 51 to 38 and add pin#19 to existing fuel pump relay wire...... thats not very hard at all..... every sensor that the mustang has thunderbird has.... and the map...
  7. ford_thoroughbred

    88 T Bird help

    the harness swap would be a waste of money due to all i have to do is add basically 5 wires to the original harness and swap ecu's... from what i've been reading its a roller but different cam, heads, and intake from other forums..... i found a tfs stage 1 cam for 100 i plan on getting but im...
  8. ford_thoroughbred

    88 T Bird help

    its not ho nothing aftermarket ont this car its all original... im going to the maf setup and all but didnt know if the pistons were the same. i know it has different heads, cam , intake and stuff already... i wanted to put the gt40p heads once i started building but cant find headers the gt40p...
  9. ford_thoroughbred

    88 T Bird help

    questions about the 88 tbird 5.0.is the short block the same as the ho. will mustang headers fit? been looking for answers but there not very specific so there not too helpful. so if somebody knows a good bit help me out... i know top end is a different set up but are pistons the same?
Top Bottom
Back
Forums
Menu