Search results

  1. vfast

    Running To Hot For Me!!!

    again what is the timing set at? have you burb'd the system?
  2. vfast

    Driveshaft Movement

    is the dog bone still there? i would replace the u-joints
  3. vfast

    Running To Hot For Me!!!

    what is your timing set at...have you checked you rad hoses to see if they are colapsing? have you pull the rad cap to check flow?
  4. vfast

    Spark Plug Question

    51 is ok
  5. vfast

    Drivetrain Basic Mod Questions

    forget those plugs instead invest in a MSD..13 degrees would be ok but not more...the stock paper filter flows more when new than the k/n...i'm shocked that the air silencer is still on it....i would get a better shift kit...no tune is required...
  6. vfast

    What Kind Of Top End Kit

    i would upgrade even on a stock engine
  7. vfast

    Running To Hot For Me!!!

    do you know the cfm of the fans? a cowl hood would help.. i would install a fan controller....what is the timing set at? do you have convertors on car?
  8. vfast

    1990 Fox Body State Patrol Car Rebuild Or Not ?

    there would be no real increase in value in restoring this car to factory spec... lucky for you there are a ton of factory parts to rebuild...
  9. vfast

    Dr Gas Worth The Hype?

    it's a nice piece but unless your a racer needing every last hp without worring about your coin then ok... i have used them over the years..mac sucks as you have seen the rust fast as hell
  10. vfast

    Break Booster

    replace the rubber line
  11. vfast

    92 Mustang Wont Start When Warm

    original coil?
  12. vfast

    Running To Hot For Me!!!

    that converter generates alot of heat...i would use the largest cooler i can fit...when is the fan coming on at???? your fan stat might not be working correctly..sometimes a pusher fan helps this problem. and yes you need to change your lines. going to a deep trans pan will help
  13. vfast

    Electrical 93 Lx 5.0 Timing Advance Issues Need Help Bad

    what does the egr valve look like inside?
  14. vfast

    Engine Mechanic Says Sticking Valve Guides

    you need to go over your rockers again and lossen them by a 1/4 turn to start..do you have the right push rods for heads?
  15. vfast

    Engine Mechanic Says Sticking Valve Guides

    if you have a burnt valve it would pop..you could put your hand on the end on the tail pipe and it would suck on it...i would do a visual with the v/c off and running
  16. vfast

    Engine Hmm...is It The Gauge Or Am I In Trouble?

    get a mechanical gauge
  17. vfast

    Running To Hot For Me!!!

    i hope you have a 3 core rad? i only use a mr gasket 180 stat the ofice is larger and has a hole in it for balance. what is your timing set at. what size trans cooler are you using? are you using a stock fan? check clutch in it
  18. vfast

    Help! Code 95/96 1992 5.0 Lx Crank-no Start

    again has the ignition switch been replace?
  19. vfast

    Electrical Checking Timing Want To Think It Through First

    if you moved 1 tooth then the plug wires might need to be move 1 hole over so that 10-14 degrees can be seen with timing light...i would really look at the rubber on that balancer first...any cracks :poo: can it asap
  20. vfast

    Changing Timing Cover Gasket

    nothing beats doing it yourself huh? :-]