Search results

  1. M

    Fuel New Build Running Lean

    Please HELP i'm at wits end. I have a boss block 363 with custom grind cam, afr 205 heads, 78 lb fuel injectors, pro m 98 mass air meter, trick flow type R intake, A-1000 fuel pump, 1.75 hooker headers, and i'm using the pro m efi computer that replaces the entire factory computer, vortech v-7...
  2. M

    Engine Guru's Strut Your Stuff

    I need real help. I have a brand new z363 boss short block with 200 miles on it. I have AFR 185's (1 year old) with 1.72 scorpion rocker,x303 cam,and new trick flow R series upper and lower intake. Today was the first day that I notices it smoked at low rpm's just for a couple of seconds then...
  3. M

    Transmission Question

    Looking to upgrade my t-5, leaning towards tremec but which one can I use?
  4. M

    Mass Air Meter Help

    Can a BBK mass air meter be recalibrated for 24 lb injectors? If so what kind of place does it?
  5. M

    Back Firing

    Please help any ideals welcomed. When I let off the throttle it rumbles down but it is loud enough I would consider it a back firing down. Stock bottom end, E-303 cam, 185 afr heads, 75 mm throttle body,24 lb fuel injectors, timing on 11 degree, egr delete, fuel pressure at 38 lbs,1.7 rockers.
  6. M

    Supercharger Question

    I found a used novi 2000 on craigslist and need everyones help. It was just rebuilt and a 13 psi propeller was installed. How do I inspect charger to make sure it's good. 2 question is this unit a good match for my set up? I have AFR 185's with 58cc, the block was decked by previous owner...
  7. M

    Engine Push Rod Lengths

    Just purchased afr 185cc aluminum heads ,will I need longer push rods.
  8. M

    need brake upgrade knowledge

    Need help? Can I use newer cobra 13" rotors and calipers? And what year of donor car do I look for? And is this the best bang for the buck?
  9. M

    fuel injector mass air question

    what will happen if I install my 24 lb injectors in motor with my 19 lb mass air sensor? This will be very temporary but I'm itching to get them installed. I tried to find a similar post with no luck Thanks alot.
  10. M

    Refinish quarter window rubber

    Is there a kit to refinish the seals on these windows or do I have to buy new windows?
  11. M

    Quad shock question

    What can I do about the rear end shift every time I hit the gas? There is no quad shocks. Is there something beside quads that I can do to stiffin up the rear, I have not done anything to the rear yet. Thanks
  12. M

    Rearend swap

    Can I put a 1996 rear end with disc brakes under a 88 fox body? Do I have to change brake booster for this to work.
  13. M

    New rims in near future

    What is the widest wheels I can run on the rear of a 88 foxbody? And while I'm at it what year models of rear ends can I put under same car so I can have rear disc brakes?
  14. M

    Fat running 88

    I got this car about 7 months ago and it ran rich when I got it. Since getting it I have done the following under the hood ... MSD 6al E 303 75 mm throttle body 75 mm maf 19lb cold air intake super 44 flowmasters egr block off plate 9mm plug wires new cap and rotor button...