Search results

  1. A

    Please Help With Code 67

    Alright. I buttoned every thing up and tested for continuity and all is good. Fired the car up and took it for a nice test ride, so far so good. I hope this fixes the problem. What I found was the 02 harness had been changed and the jumper was in the wrong location. That caused 12v to be sent to...
  2. A

    Please Help With Code 67

    Thanks liljoe. I checked and there was 12v at that connector. Just got it fixed now. I did the ground test. The readings I got between all the sensors and the computer test connector all the way to the eec are good 0-.2 ohms. What i did was test the grey/red wire from the clutch pedal switch to...
  3. A

    Please Help With Code 67

    Thanks jrichker. What I've come up with so far is that the circuit 46 at the eec is burnt just like in the link you sent. I got it repaired now. I traced the wires from the clutch and nss connector and there sems to be a problem with the nss connector. On the nss connector there are three wires...
  4. A

    Hello Everyone

    Thanks for the welcome guys. Madspeed your car is pretty slick. I like the Bullet wheels.
  5. A

    Please Help With Code 67

    Thanks for the replies guys. jrichker thanks for that picture of the pin out. I was going off of another diagram that I found and pin 46 was in a different spot (55) than in that picture. I will do some more checking. liljoe07 thanks. I didn't know I had to heck the back also. I will check...
  6. A

    Please Help With Code 67

    Hey everyone. Just got the car and it has a problem that I've haven't been able to figure out. The vehicle is a 92 Mustang GT that came from factory with a 5 speed. When I start the car up it will rev to about 2500-3000 rpm and the engine light will be on but some times (1 in about 5-6 starts)...
  7. A

    Hello Everyone

    Just wanted to start off by saying hi to everyone. I just purchased a 92 Mustang GT and love it. The car came with the basic bolt on stuff : cold air intake, BBK shorty headers & catted h-pipe and Flowmaster exhaust. Any way looking forward to being a part of this community. Here are a couple...