Search results

Does anyone know where to find the bolt size specifications for a 68 302? Specifically, I am looking for the water pump bolt sizes, timing chain cover bolt sizes, exhaust manifold, and oil pan bolt sizes. I figured out I can save myself about 60 bucks by going down to the local hardware store...

I'm restoring my '67 and the paint has some serious oxidation. I'm using some rubbing compound now and it is turning out great. Below is a pic of just one coat of compound on one side of the trunk. I usually have to do this about every 3 months. Does anyone know if there is a coat of something...

I'm switching out the pads on my 03 Mach 1 and noticed this spacer type piece that was slid in with the pin which holds the caliper on. I've attached a pic. It's pretty torn up and the new set didn't come with one. Is this piece really necessary? I looked up a few how to videos and didn't see...

When I pulled my trans off last week, the wiring harness connector that sits above the trans (and runs to the side of the trans and rear O2 sensors) came busted off. I re-hooked the connection before installing the trans. It seemed to connect okay. However, the speedometer, odometer, and rear O2...

I pulled my starter during a clutch install and didn't take a picture of which wire goes where. It's a 2003 Mach 1. There are three posts on the back of the starter/solenoid. There are two wires. One a larger gauge, the other smaller.

When removing my trans I found this loose washer hanging around the shifter. Anyone know what this is for? I believe the previous owner had an aftermarket shifter installed at some point. The two bolts shown in the picture are practically welded into their respective holes. So the washer can't...

The throw out bearing finally went out in my '03 Mach 1. I'm in the process of pulling off the mid-pipe and trans crossbar. I tried the trans crossbar first and the bolts absolutely will not budge. I applied WD-40 and used a cheater bar. The socket extension I was using actually bent. I moved on...

I posted this in the Mach 1 section a week ago, but no dice so far. I thought I'd try the general section. I've got an '03 MAch 1 with a check engine light that has been on for a while now. I've ran the codes which showed a bad O2 sensor. I relpaced the sensor and the light is still on after...

I've got an '03 MAch 1 with a check engine light that has been on for a while now. I've ran the codes which showed a bad O2 sensor. I relpaced the sensor and the light is still on after resetting. Today I noticed two loose hoses coming out of the side of the intake. Actually, out of the side of...