Search results

I data logged the a/f ratio percentage. I checked the pressure in the rails which is fine, and check all vacuum leaks and actually improved the ratio (mechanic forgot to put on the air filter:bang:). Clogged injectors maybe be possible since they are original, and I am not sure which fuel was...

Okay, did you go with the Accels? Also, did you need a tune or was it a direct swap with no issues?

Hey everyone! I recently done a full PI swap and car has been running a bit lean. It still using stock injectors so I have been thinking about swapping for some new fuel injectors. Both LateModel and American Muscle have 19lb and 24 lb ev1 injectors, but which option would be better suited? The...

Yes, it raises the compression ratio to 10.3:1 or around there I believe. The tune is for the PI swap and for the gas i usually run ( 90 no eth). Prior to the tune it had these issues. After the tune it is running better but the idle still tends to flux and possibly drop during the initial...

Hello, I just finished my PI swap, brand new heads and intake, and I'm experiencing idle issues. I will start the car an it runs fins for a few seconds and dwindles down until it stalls out. It does this while driving for a bit until the temperature gets to about half way. Once it is warmed up...

It was a sad turn for me. Now I have some debating to do, again.

I believe so, they supplier just said "Not really sure to be honest. I believe it's needed for a bolt in the rear."

Nice! Picture? I have messaged the supplier asking for the back spacing but i know the max offset is 25+ on the xt-005 wheels I was talking about. Looking at the FR500 wheels from AM they run a 24+ offset and a 5.94" backspacing. So it seems like only the back spacing is in question for these...

At Mattstang04- They are awesome looking wheels. I think I will just call the manufacture and as for the backspacing spec and if they know if they will fit on our cars. Gearbanger- Sweet, what tire size are you running? 275? do you like the slight "stretch

I'm getting MM caster camber plates as well, and there is a shop near me that offers a similar alignment warranty. Hopefully I will be all set to go then.

Yeah it was very well written. I should have specified my tire size as well haha. I was planning on 275/40 up front and not sure if i am going staggered or not yet. More or less I was worried about the clearance of the wheel (tire included) on about a 2.5 inch drop. Currently I am running 275/45...

Yeah I have noticed there is a small selection of rims geared towards our cars, and a lot of the foreign ones do not have the needed spec. The MRII do look really good and the prices are fair, but the off set only goes up to +10 on the MRII :(. Well I was just looking for something a bit...

The specific spec i was looking for was the +25 offset, but i am not sure about the backspacing though. What back spacing would be ideal?

Not sure yet. Maybe 275's. Looking for opinions. I think its a good looking option beside the usual bullits or cobra wheels.

I was looking at a different style wheel and came across these. With an 18x9 114.3 +25 fittment they should fit right? Just wanted to get some opinions. https://www.cosmisusa.com/shop/xt-005r/

Thanks!

No problem, anything but multi-variable calc....class blows:bang:

Thanks! I have read around a bit before joining and have seen the tons of useful info. I am currently a student at Rochester Institute of Technology for Mechanical Engineering Tech. and hopefully I can contribute to the discussions. Pictures soon!

Hi, Brand new to this site, and mustangs as a whole. I used to be an import driver ( civic of course) but my father was always an american muscle head. One day stumbled upon a 98 gt with 35,xxx miles and a good price and here I am. Looking to make a good daily driver to back up that growl of...