Search results

  1. Restomod 67

    Which carb for my set up...

    Carb selection. Hi, With such a combination I would recommend you a smaller carb. The 289 Hi-Po engine came with a 480cfm and it was more than sufficient. If you go with a 600 cfm or more with a vacuum secondary, the secondary’s risk not opening at all until at least 7000 rpm's and you...
  2. Restomod 67

    6 to 8, use 8 or 9?

    You'll need to swap the rearend just to have the 5 bolts patern and better axles. To determine if you need an 9" versus 8" the tires are an important factor. You can have all the power in the world but if you spin the tires instead of having traction then the rearend isn't that important, an 8"...
  3. Restomod 67

    another cooling question

    When you raise the pressure it also raise the boiling point of your coolant, it won't cool the engine better, just raise the boiling point.
  4. Restomod 67

    Another setup #s guessing game...

    Nice combination for the street but the gear seems too much for that cam. At the track you won't be a superhero but on the streets it will be more than adequate.
  5. Restomod 67

    C4 oil change question

    I've included a drawing, maybe this will help.
  6. Restomod 67

    How does this setup sound to you guys...power guesses maybe?

    This might be of some help to you, i built the exact same combination as you exept with a 600 cfm dbl pumper carb. It produced just a little over 300hp (I'd have to find my old dyno sheets) but i had almost no power and torque before 3500 rpms, hated it very much so i swapped the cam for the...
  7. Restomod 67

    C4 oil change question

    I just removed the oil filter and a spring with some kind of a dowel pin came out. Now, i don't know wich side is up for the pin. Does the flat side goes against the spring or inside the valve body? Thank you
  8. Restomod 67

    Need help to find master cylinder

    I'm looking for a dual chamber, 7/8" bore with the outlets towards the fender and preferably for front disc and rear drums. This is for a 67 with a Wilwood front discs set up. Thanks for your help.
Top Bottom
Back
Forums
Menu