Search results

Hi Guys, I'm searching through the junkyards to find a T5 Transmission, and I was wondering if anyone had the door tag codes for the various Transmissions used in the 80's & 90's. I was expecting a single digit like in the old days, but the few I looked at had about 5 digits...

I'm putting together some car show signs for my '72 Mach 1, and I was wondering if anyone could tell me the names of text fonts that would match, or come close to the ones used for the emblems and decals of 'Mustang' and 'Mach 1' in '72 Also if anyone had an electronic image of the...

Hi I'm looking to install a fancy Autodimming Mirror with Compass &Thermometer in my 06 coupe, and the wiring requires I take off the Drivers side A Pillar Trim. I polked around a bit last night, and didn't find an obvious way to remove it without wrecking it. Any pointers ?

Guy's, I've been mucking with the accellerator pump on my Holley 750 on a relatiely stock 351 Cleveland. I have the Holley manual, and altough it says that the cams can be replaced to give larger, or sooner shots, it gives no information. I looked at a bunch of cams from other...

I've been cleaning up a '72 Q-Code engine to put into my '72 Mach 1. which was rebuilt and bored out .01, but is otherwise pretty much stock. Rather than screw around with the points, I'm putting in a Duraspark unit from a '74 Torino. I had the new distributer all apart, and was going to...

Hi Guy's, Been off the board for a while... I've recently lucked into a set of flappers and a Plenum for Ram Air in my Mach 1. That just leaves the Air Cleaner, which is a pretty unique device. Someone sells a fiberglass repro on the net for $425, and crappy originals can go for upwards...

Hi guys, I've been hanging out in the Classic & MII frums for years, as I've got a cople of old cars, but I just brought home a new 06 Coupe for my daily driver, and I'm looking for an outlet fro my enthusiasm. So far I love it !

Can anyone tell me the correct color code for the engine in a '72 Mach 1 ? Also if you could describe the color. I picked up a can of 'Ford Blue' engine enamel, which is sort of a sky blue, but the remnants of paint on mine is a deeper blue, anmost the color of the Stangnet Banner on...

has anyone come up with a source for replacement seatcovers for a '77 MII ?

I'm repairing all the electrical in my car that was messed up over the years, and have run into a snag with the seatbelt warning light system. I have schematics, but for some reson they don't show some of the circutry. I understand whats going on in the seatbelt retractors In the dash...

Folks, I've been toying with the ideal of moving up to a 5 speed in my 77 II with a 302. I've read several threads about the upgrade, but have yet to have a transmission fall into my hands. While prowling the junkyard, I didn't see any 302/5spd combinations, but I did see...

Guy's, I posted this on the MII forum but didn't have much luck, I thought their might be some Carb Guru's here.... This summer I installed a holley 600 and manifold off an ~83 into my 77, which has an otherwize stock 302. (It's OK, my other car is a '72! ) it's all running fine (even...

Guy's, This summer I installed a holley 600 and manifold off an ~83 into my 77, which has an otherwize stock 302. it's all running fine (even the automatic choke !) except for one little thing. If I'm cruising at about 60, and then just touch the gas, it will balk then go. It's...

Guy's, There has been a ton of discussion on this over the past couple of years. I'm gearing up for it, and have read through all the old posts I could find, but I'm down to two questions. - The manual says that with the hydraulic lifters if you're outside a certain tollerance...

This weekend, I put a 4bbl carb/manifold from an 83 mustang into my 2. Everything seems to be working OK, except I'm not convinced the vacum secondaries are opening. They're certaintly not if I just rev the engine in the shop. If I remove the solenoid from the Carb, I can't sense any...