Search results

This topic might not get many reply’s, but I was curious as to your thoughts. I got an email today from LMR. They’re reproducing 10 hole wheels. Priced at $550 a set! I’m was kinda shocked to see that. A few years ago you couldn’t get rid of these wheels for a $100 total. Is this a...

Long time member. Went inactive for a while. Since I’ve reactivated my account, I’ve been looking for a reason to post. This one’s a good one. Before I get to that, I’ll tell you about the car. It’s a 89LX with a fully functioning terminator swap (A/C, cruise, wipers, etc) all while keeping the...

Had my car painted 1 1/2 years ago. Had a cervini hood installed at the same time. I know the included instructions recommend that the hood be baked in an oven or installed for some time period prior to painting. I informed the owner of the body shop. He said he would bake it prior to any paint...

After reading/searching for info about EEC tuning. I have decided that I want to go the Tweecer R/T route prior to my stroker build. I have a pretty good understanding of the basic operation of the EEC IV. Just have a few basic questions that a search could not answer. I know I'll need...

2 years and 30k ago, I installed a set of 3.73's. Hasn't leaked a drop, until now (inspected often, especially the first 6 months after install). I'm positive it's not the cover leaking. I used the 8.8 rebuild kit from summit. All new bearings, new crush sleeve, new seal, new pinion nut...

First, I've tried searching. Haven't really found any info on pedal compatibility. I'm planning on converting my 67 coupe from a C4 to T5. I will use the Mustang Steve cable kit, T5 tranny and bell, crossmember, etc. My only question concerns pedals. The car is a factory power brake...

First, I have read and followed the Surge Idle Checklist multiple times. Yet, I still have the hanging idle (1600rpms) that is always temporarily fixed after an ignition cycle. Because of this, I'm almost certain its an issue with the TPS. The following has been replace or cleaned in the...

I dont know if it's the weather (very humid, sudden temp change) or...something more serious. I'm fearing the worst. Some of you that have had heater cores go bad...does this look familiar? There is no coolant on the ground or dripping from the drain hose.

First off, I have searched and was prepared to run through jrichker's list....until now. This morning my car didn't start. It was fairly cold ~30F. The fuel pump would not prime. With what little time I had, I placed my hand around the pump relay and could not hear or feel anything when...

Cruise control stopped working the other day. Here's what I've tested. VSS - good Vacuum release valve - good No blown fuses Horn works It appears I need to replace the servo module. From searching, looks like they are no longer produced. Will have to go the junk yard route...

Here is the setup: These have been replaced or installed in the last 20,000 miles MM Coil Overs with Bilsteins MM CC Plates MM Tubular Arms Replacement steering rack and tie rods Had the car aligned to MM specs approx. 4,000 miles ago. The steering is still sloppy. It feels the worst...

Hello everyone. I don't venture to the special production forum much, have a question for you guys. My dad is looking at 2004 Saleen. http://cgi.ebay.com/ebaymotors/ws/eBayISAPI.dll?ViewItem&_trkparms=tab%3DWatching&viewitem=&item=320272290325&_trksid=p3907.m32 Besides the obvious...

Converted to 134a last summer. Did it proper: condensor, compressor, evap flush. All new o-rings, dryer. Filled with 8oz PAG. Was never happy with performance. I don't think the person who pulled the vacuum did it long enough. I also think he overfilled it. Had system emptied at shop...

Today on the way home from work. I noticed my electric fan was not working. I then noticed my HVAC blower was not working. NOTE: The "key on" wire for the RELAY for my electric fan is piggy-backed on this circiut at the fuse block. Checked fuse, it was okay. When I turned the key to the on...

Car is back from body shop. :banana: :banana: :banana: :banana: :banana: I talked to the owner and decided to have the whole car repainted. Got to go out for a while so, will not be able to reply for a couple hours. Enjoy!!!!! :cheers:

Hood arrived today. :banana: :banana: Going to body shop Monday. :spot:

Just got in a wreck. Someone made an illegal turn in front of me. Did everything I could to miss them. Hit his front door with my left front. I was following him on a two lane road with a turn lane in the middle. He put his left turn signal on and moved into the turn lane. He slowed...

I'm trouble shooting a problem I have only during highway driving. It feels like a slight miss, but only happens on the highway. It is not consistant, only under light load and does not happen when accelerating. The car ran an 8.64 @ 82.2 mph with mods in sig on street tires. It's safe to...

Finished up my five lug, cobra brake swap. Also installed Eibach Pro's and MM Rear lower control arms. Though I'd show everyone the before and after.

About to finish 5-lug swap. Having a hard time installing the 93 cobra booster. Feel free to offer tips, pics, whatever. I dying to finish and take it for a spin. Edit: Guess I should mention. I did take a hammer to the strut tower. Not enough clearance. Might have to buy a 5lb sledge...