Search results

For Sale: 2003 Mustang GT Gunmetal Grey, custom paint job (ghost flames, see hood picture) 5-speed trans 75,804 miles asking 9,200 / obo Mods: Custom Paint Shorty BBK Headers BBK short throw shifter 373 Rear end Flowmaster cat-back; also comes with an off road x-pipe not installed on car...

i have the stock air intake (airbox and tube that connects to the throttle body - mass air sensor not included) parts are from my 2000 gt I live in willow springs, IL (near chicago) asking $30 email with questions: [email protected]

I have the oem fog lights from my 2000gt -- one of the lights has 1 of the mounting tabs cracked off, but two still remain so you could probably still use it with no problems I live in willow springs, IL (near chicago) asking $15 each email with questions: [email protected]

I have the stock k-member, springs, and a-arm from my 2000 GT. I live in Willow Springs, IL (near Chicago) -- I am willing to ship. Asking 100 for everything or separately 80 for the Kmember; 25 per a-arm; 20for the springs the ends of the threads on the ball joints are slightly...

Asking $9,200 OBO. Car is in willow springs IL, garage kept, near mint condition. email: [email protected] phone: 708.670.2265 Mods: Steeda clutch firewall adjuster Steeda clutch pedal adjuster Spec Stage II (I think) clutch and pressure plate Mac ceramic coated long tube headers...

I am thinking about buying a house which may mean I have to sell my mustang. :( Not sure what I could ask for it and I am looking for advice. Here are the details: 2000 Silver GT about 40,000 miles Garage kept - near mint condition, only used as a daily driver for about a year or two when the...

I installed a D&D tubular front suspension and CC plates/coilovers recently and the slightest bump sounds so loud in the car. Has anyone else installed coilovers and had this, I am wondering if I should get a different brand of coilovers or maybe there is just a rubber noise isolater I can add...

I was replacing my clutch on my 00 GT, and the trans was real dirty, but just the back of it. Their was some old trans fluid gunked on the bracket that holds the rear O2 wires up, which is right below where the drive shaft yoke slides into the trans. Should I replace this? Do I need a special...

I am installing long tubes and will be dropping my stock k member to make the install easier. I was thinking about getting a new K member/a arm/coilover kit. I was looking at the D&D kit. I also heard PA racing makes a good kit. Does anyone use this type of setup on their daily driver or...