Search results

I just picked up a '92 LX hatch 4 cyl. This is the 4th one I've had. I also still have a '93, same car. This '92 the steering wheel seems to point downward. I can barely squeeze my leg between the seat and the wheel. Never had this problem before. The '93 is no problem. Is there some kind of...

I just got a '92 4 cyl. LX hatch that needs the seats replaced. I picked up a full set of seats from a 8 cyl. LX fox, not sure of year, but the new seats have the lumbar support and the old seats don't. Will I find the wiring for these under the rug or somewhere or is there nothing there. If...

I just picked up (another) '93 LX. I put about 1200 miles on it and had an issue twice. Out of nowhere, the car feels like it's running on 2 cyls. and the check engine light comes on. Also, the tach dropped about 1000 rpms while it was running like crap. It cleared itself up both times after a...

I put an A4LD from a 1989 LX into a 1991 LX, both 4 cyls. The problem is that the '01 had a 3 wire plug and the '89 trans has a 2 wire plug. The plug can't be changed easily. I believe the plug is for the overdrive and/or lockup being the car now only has 3 gears and no overdrive. I want to...

Hi. I am getting 3 codes on my kids '91 LX 4 cyl. Code 172, 186 and 334. 172 (R,M) Oxygen sensor not switching - system is or was lean - Single, Right or Rear HO2S - Fuel control 186 (M) Injector pulse width longer than expected or Mass Air Flow (MAF) lower than expected -...

'91 Mustang . I put a new door lock actuator in and it didn't last too long. Does the fuse for the power locks have anything else on the same circuit, as in what else may not work if the fuse is blown?

I bought my Daughter a '93 Mustang LX 2.3 about 2 months ago. I did a rear main seal and an oil change when I got it and a few hundred miles later, it was down a quart, same thing a few hundred miles later. All in all, I figure it lost about 4-5 quarts of oil in about 2200 miles. There are no...

'91 4 cyl LX. Tuned the car up and also did the pcv valve. I now have oil coming out from underneath, I think the rear main seal. Would a bad pcv valve make enough pressure in the engine to blow the seal? If this is the case, is the seal still ok or does it need to be replaced? Thanks.

I am looking at a set of rims for my '91 lx. The guy who has them says they are 3.5" center to center and thinks my '91 is 3" center to center. The rims are off an "older" Mustang, but I don't know what year. Is the '91 3.5"? I don't have the car here to check. Thanks...

Does anybody know the width of the poly cast 14" rims that were stock on the early '90's 4 cyl. LX's? Thanks...

Help! 25 out there and I don't have any heat. Car runs at the right temp, but only blows cold. Car doesn't overheat or anything, just no heat. Car is a '90 LX 5.0. Where do I start??? Thanks...

Is it safe to assume that a 6 cd stereo out of an '03 GT is in fact a "Mach 460"? I need to replace mine but guy can't say if it's a mach 460 or not. I'm not all that familiar either. Thanks.

On a '03 GT, is there an adjustment to get the windows closer to the weatherstripping? Not up and down, but more like pushing in on the window from the outside. I have a gap pretty much all along the back edge of the window. I did a search and didn't find anything on this. Thanks.

On my '91 LX 2.3, the tc stopped locking up. Around the same time, my cruise control stopped working. This all started when I had a problem where the cruise would not shut off when I hit the brake. You would feel it go off, but when you came off the brake, it would start speeding back up. Also...

New option: If I have an '84 with a 5.0 already carbed, but it has a 4-speed, do I have everything I need to swap the motor and trans. to a '68 that is an automatic? If not, what else is needed? Thanks.

Would a motor and trans. from a '90 LSC just "bolt up" in a '68 Fastback or are there a lot of modifications needed? Also, is it a nightmare to try and hookup the fuel injection and computer and all or is it better and easier to just change out the manifold and put on a carb? Thanks.

Does anybody know the Ford part # for the EGR valve for a '91 2.3L non turbo or what years share the same one? Thanks.

Well, been through the mill on this '84 SVO. Seems to have a bad VAM. Problem is, it's extinct as far as Ford goes. Where can I get a new one, or, even better, is there a way around this whole VAM thing and maybe upgrade or update the car to some kind of newer system? Any and all help is...