Search results

  1. P

    Need fog light covers for Focus

    My daily driver '03 Focus SVT keeps breaking glass fog light lenses. Years ago, I had this problem with my '93 Cobra, and the fix was a pair of GTS clear covers to protect them. That company does not make them for the Focus SVT, does anyone know of one that does? No luck searching the web, any...
  2. P

    Engine Builder - Arizona

    Duffee Motorsports, without a doubt or a moments' hesitation. -MJS
  3. P

    Granada swap.....tie rod question

    I've done more than a dozen Granada swaps on Falcons, Comets, and early Mustangs, both 6 and V8. Here's what you need to know about the tie rod ends: V8 manual steering cars can use the Granada tie rod ends on both sides, but the factory P/S on '65-'66 V8 Mustangs and '65 V8 Falcons and Comets...
  4. P

    Cruise wont work

    Cruise has a vacuum dump valve mounted behind the brake pedal shaft, so when you hit the brakes the cruise cuts off. Check for a vacuum leak at this valve, and check that it is adjusted properly to be activated by the brake pedal. -P51C
  5. P

    1993 Cobra.......Should I Buy it????

    I'm the original owner of a '93 Cobra. They came with 3.08 gears, 3.27s were optional only on 5.0/AOD Mustang GT/LX. They did NOT have a T5-Z, they had a special, Cobra-only T5 that had stock ratios (3:35 low) but with phosphate coated gears and a tapered roller input bearing. They had a special...
  6. P

    Cruise control pulses?

    Ford cruise control reacts strangely to some engine mods. You sometimes get a pulsing effect when a Cobra or GT-40 intake is added, which is the reason that the '93 Cobras didn't come with cruise. When you add a cam, all bets are off - a pulse is an almost sure thing depending on how radical the...
  7. P

    Where is the cruise control module located on a Fox?

    The ones that I've pulled out are a rectangular white plastic box with two plugs - one from the dash harness containing the power, ground, steering wheel control inputs, and VSS input, and the going to the servo. -P51C
  8. P

    Anyone use a crane Hi-6??

    I run an HI-6 BTM (boost retard model) on my blown '93 Cobra. My first Crane box was gold colored, and died with less than 2K miles on it, causing the engine to not rev past about 2K RPMs. I sent it in asking them to repair it, but they replaced it even though it was not under warranty. Pretty...
  9. P

    2001 Spindles on my '87, what does it take to fit?

    They bolt right in, but you have to use spacers or a stack of 3 or 4 washers under the lower ball joint nut to tighten it down. You'll see when you get there. -P51C
Top Bottom
Back
Forums
Menu