Search results

About 4 years and 60K miles ago I replaced my original bearings and seals with axle savers. I just finished replacing those with the standard bearings and seals. Why replace again? The savers were leaking. Why I haven't figured out yet. I couldn't find a seal that would go in place of the...

Long time owner here with 170K original miles. I haven't experience any major problems. Only had one plug blowout due to not using a torque wrench on it. Had to replace the rear axle bearings. Minor ones are my driver side window motor is acting up. Not sure if it's the motor or switch...

GasGuzzler00, did you ever experience clutch stuttering/chattering before it started slipping? Did you replace the clutch yourself? If not, approx. what was the labor cost to replace?

You mentioned changing coil boots. Could be you have one or more bad coils. I've had to change all mine out at about 93K. Also, clean the MAF, throttle body, IAC valve, and use Seafoam in the upper intake and gas. Change the air filter if needed. Use the recommended 5W-20 oil. Use fuel...

A while back I replaced all 8 COPs with Granatellis, and have already had to replace 4 of those. I'll never buy GMS COPs again.

Might be a bad coil-on-plug.

It's a daily driver, so I don't get too spirited with it very often. But do want to hold on to it for quite some time. Love to drive it still, and love having no car payments. Any idea what else would need to be replaced in the rear? Many thanks for both respones.

Don't know if they were or not. The car only had 41K when the gears were swapped. Probably weren't since I did not ask the mechanic specifically to do that.

2002 Mustang GT with 128K miles Issue 1: Replace pinion seal - Got Ford shop manual and Haynes manual. Will borrow all the special tools. Besides following the manuals, is there any advice/watch-out-fors you guys can pass on to me when replacing the pinion seal? Issue 2: Replace axle...

You haven't mentioned replacement of the fuel filter. Might want to clean the MAF sensor if never done.

My SCT chip failed, and caused my car to quit at speed. Pull your chip, assuming you have one, and see if anything changes.

Johnson's Mustang & Truck Prts - Chesapeake, VA, 23320 - Citysearch

Ford doesn't carry them that far back. I found it on autozone.com of all places.

He has a convertible 1986 Mustang with the 3.8L V-6. It's missing the vehicle emission control information label that used to be on the fan shroud. He would like to tune it up, but needs the timing information off of it. Also, he would like to get the vacumm line diagram that is supposed to be...

4921 Canton Road NE Marietta, GA 30066

www.svpu.com

Suggest you visit the Kenne Bell forum on Modularfords.com.

Across the water in Hampton.

The me, myself, and I club.