Search results

Try True Blue Performance In willow Springs NC, Just out of Raleigh

check out Anderson Ford Motorsport, they make some of the best powerpipe's most of the magazine's go to these guy's to test all the bolt on parts, they found that on the 03's not many of the pipes out there did anything, but they did find that one of there own filters gained 10hp check out the...

just in case anyone is intersested http://cgi.ebay.com/ebaymotors/ws/eBayISAPI.dll?ViewItem&item=7906698338&indexURL=1#ebayphotohosting

I use my car as a daily driver as long as you weren't crazy on getting into the gas when it was raing they were fine, that is one of the reasons i went with the nitto's I heard others saying they were surprisingly well in the rain, and they were right.

I had 275 40r17 on my 97 cobra just replaced them after 16000 hard driven miles, they are great tires I honestly didn't expect to get near the mileage I got out of them, I just bought 315's my rim size is 9.5 they weren't even close to fitting the rim, I think Nitto recomends 10.5 at least...

thank you very much for the info, now I can buy my weld prostars

vehicle is not going to be a strret car, just a playtoy to start doing my fabwork, it will be a good starting point for low budget, as long as it takes project, and when one weak link brakes upgrade one thing at a time. so basically the car is just to have fun fabricating my own ideas thanks...

no doubt but it's a starting point for the setup to do all fitting and what not until money can afford a better trans

thanks for the info

does anyone know if a 15 inch wheel will fit on a 97 cobra, I want to get a set of MT Streets in 15 inch but not sure if 15 inch rims will fit thanks for any help Brian

I haven't found anthing onthe part numbers, do you just use the same pilot bearing that the 2.3 the trans came out of uses. thanks for the info Brian

I'm building a low buget 5.0 turbocharged thunderbird, my question is, I've heard you can use the T-5 trans from a 4cyl but you have to use a different pilot bearing, has anybody done this and have any part numbers to use to get parts. thanks for any help Brian