Search results

If your hearing a clicking and it feels like its putting the engine under load then the ac compressor is coming on. Other than the clutch on the compressor engaging there is nothing else in that system that will load the engine.

What are the exact codes on that? The o2 sensors when looked at on the data stream are supposed to go lean/rich/lean that is their job to be constantly monitoring the a/f ratio. That is how the ecm runs your car. A little more info would be great in diagnosing your problem.

The stock speakers are 6 ohm and the ones he has are 4 ohm so it seems that the amps are going into protection because too much power is being asked of them. I dont see how people say they have switched to aftermarket without problems, i would expect that somewhere in the volume range the amps...

the mr.freeze is methanol injection if im not mistaken, its supposed to help with detonation and at the same time add power because it allows you to add more timing. As others said though either get a spot on tune or get a real bottom end. I want to supercharge my 97 but i will hold out until i...

thank you very much for the hassle.

If someone could do this one for me i would really appreciate it: 1HGEJ6221TL008794 email:[email protected] thank you very much

wallmart carries both the adapters you will need, your total expense will be around 30 dollars. You can go without the level adapter but i reccomend you get it as it sounds much better with it.

I did the same mod on my friends 98 gt and it worked, i might try it on my cobra.

As far as i remember they dont have a gas light. I have owned a 95 gt, 95 v6 and now a 97 cobra and none of the three cars had that light. I believe the newer (99 up) cars have it.

I just got my car back from the shop, they put in a new clutch and im having trouble with it as well. I guess its just the break in period because it feels better and better as i drive. When i first drove it out of the shop i stalled a couple times trying to take off, but now im getting the hang...

I can get you the wiring schematics, i have them on the diagnostic pc at work. What exactly do you need? is it a certain circuit? i have all the wiring schematics so let me know.

Your car will not know the difference between 15s and 17s, And if you havent noticed there is plenty of space in there to stuff up to 18 inch rims and tires before running into clearance issues. The ride does get harsher and firmer but along with it comes much improved handling. Your car will...

I hope your joking. Head gaskets are not hard to change, but there is a lot to do so im sure it wont be done in 2 hours.

yes if you want to spill the trans fluid in the converter all over your floor, usually its better to get both down at the same time.

just wondering, did you also remove the torque converter nuts?. If so you just need to slide the trans back with some help it should come down. I dont know how you got the bolts out, but the way to do it is by dropping the trans crossmember and transmission mount first. This allows the...

Have someone outside the car to see if the brake lights come on everytime you hit the pedal. IF they dont then for sure you have a bad brake switch.

do your brake lights stay on right before it blows without you depressing the pedal?

do not hit the rotor where it makes contact with the brake pads. Hit it on the part that sits on the wheel hub, be careful not to hit the wheel studs either. If you cant get them off i can give you a hand if you are in Chicago, somewhere close to me. Im sure they will come off.

It could also be your balljoint going bad, i suggest getting it checked before doing anything. The tie rod is very cheap($20-40) and if you own some tools you can do it yourself just ask for help. The balljoint is harder so if you are not mechanically inclined i suggest you leave it to a...

what he said, usually you need 2 extensions and a universal joint, that should do the trick.