Search results

  1. 0

    Need Help: Clutch Install Problems

    I'm at a loss on this one and need help... Installed a Spec Stage II clutch this weekend and it went well until everything was back together and I tested her out. Once you start the car, it's very difficult to put the car in gear, and once you get the car in gear, the tires spin with the...
  2. 0

    Best bolts for LT headers?

    I did it without removing the K-Member on my 01 and I don't think a 96 would be much different. I had to jack up the engine a bit to get the passenger side LT to clear, and it does make for a tight work space on some of the bolts, but it's definately do able. By not removing the K-member you...
  3. 0

    01 Cobra 300RWHP...Whats a good way to get there??

    I think that with what you have listed you should be able to top the 300 mark pretty easily. There are quite a few guys with UD Pullies, Catback and high flow H or X that are right at 300, so the MAF and timer should get over the mark. You can always opt for a CAI system or swap out the "logs"...
  4. 0

    Can anyone tell me what more mods I can do

    If your looking to eak out every last bit of HP without opening up the engine, I'd have to agree with SVTAddict and go with the LT's and a custom tune. You can also upgrade the ignition system with a MSD setup, install Denso Iridium spark plugs and opt for an electic water pump from...
  5. 0

    Best bolts for LT headers?

    I ordered a set from Stage8 for $55. You don't have to worry about them backing out with the locking tabs. Some of them were quite a pain in the *** to get on, but I did the install without dropping my K-member. It was worth the few extra bucks in my opinion. Good luck on the install!
  6. 0

    Need Help: Burning Oil and Compression Test Results

    I'm burning about a quart every 1000 miles, and the amount of smoke on WOT is rediculous...I'm talking about enough smoke that the drivers behind me have to close their eyes, drive throught the cloud and pray nothing is on the other side. I think I will try the leak down test as suggested. I'm...
  7. 0

    Need Help: Burning Oil and Compression Test Results

    Back in the summer, I blew a coil pack on the #8 cylinder on my 01 cobra which shattered the spark plug. Part of the ceramic portion of the spark plug chipped and fell into the cylinder. Took it into ford and they indicated that the cylinder wall appeared to be damaged...and they voided my...
Top Bottom
Back
Forums
Menu