Search results

  1. C

    87 no spark with spout in?

    yes it has ran fine, a little poor idle while cold. It has been about 1.5-2 years since the mass air conversion but the car has been sitting for about 8+ months. During this time I have just started it up about every 2-3 weeks and let it run for a while.
  2. C

    87 no spark with spout in?

    Jrich, I am at a dead end now and want to know if you can point me in another direction. From a perfectly running 93 5.0 I removed the distributor, coil, spout connector and "computer" and put them in the problem 87 car. The 87 still had the same problems (no spark from coil with spout in...
  3. C

    87 no spark with spout in?

    Thanks for the info jrichker. The "problem" car is an 87 with the cobra mass air conversion kit, MSD distributor and msd 6AL. My results have been the same with the 6AL or bypassing it. Got tired of messing with it today. I will check for codes tomorrow. I do have a all original 93 that I...
  4. C

    87 no spark with spout in?

    I have an 87 Mustang. With a inline spark tester between the coil and distributor I get no spark with the spout connecter installed. I get spark with the spout connector out but will not start, any ideas? Car was running fine then died on road and has not started since. I had the...
  5. C

    AOD to T5 and cruise control

    VSS is plugged in, I have one plug that is not... It comes from the top of the T5 and hangs over to the drivers side of the tranny. Any ideas?
  6. C

    AOD to T5 and cruise control

    not sure about the speed sensor, where does it plug in to. I dont remember not reconnecting everything
  7. C

    AOD to T5 and cruise control

    I did the T5 swap in my 93 over the weekend. Everything went great, have to press the clutch to start, back up lights work... I noticed today the cruise control does not work anymore. What should I check on first? I did install the button/switch on the pedals. Also, I used a brand new...
  8. C

    Plug on side of t5z?

    I am almost done with my T5 swap in my 93, just have to get the exhaust, clutch cable and console back together. On the T5z there is 2 small studs that look like an electrical connector on the drivers side. What do I do with that? What is that for??
  9. C

    intake suggestions?

    I borrowed a leak down tester from my friend, I am going to check that tomorrow.
  10. C

    intake suggestions?

    dup
  11. C

    intake suggestions?

    DMAN, thanks for the input, I need some direction on this!! I was looking in to changing intakes because I am chasing down a problem. I had the car dyno tested and the numbers seemed very low to me, I thought the intake might be hurting me... That or the stock AFR valve springs. You have...
  12. C

    intake suggestions?

    thanks Boc, my typo.
  13. C

    intake suggestions?

    thanks, theBocSez, the uppers are the same. I checked in to that already. That would be the cheapest option. I just wanted some input before I ordered one.
  14. C

    intake suggestions?

    I am going to pull the intake to check the intake gaskets, so since it is going to be off I was going to put an intake back on that matches the cam better.
  15. C

    intake suggestions?

    302, AFR 165s, X cam. I have the TFS street heat now but want an intake that works better with the cam I have.
  16. C

    intake suggestions?

    What would most likely be a better intake for the 1500-6200/6500ish rpm range, the TF track heat or the BBK SSI... or other?
  17. C

    dyno numbers--Suggestions??

    Thanks 304billet , I am pretty sure the push rods are correct. I am going to do a leak down test this weekend and post the results. I am also remembering something wierd about the intake gaskets maybe being too small(was 2 years ago)... I am going to pull the intake off and check the gaskets...
  18. C

    dyno numbers--Suggestions??

    should I step up to the TFS track heat intake (or other) instead of the street heat intake?? Also these two pulls were made about 10 mins after driving the car 100+ miles to the shop... if that matters.
  19. C

    dyno numbers--Suggestions??

    They are the stock AFR valve springs, maybe I need to change those.... I dont remember what rockers they are but they were blue. Dark Night, do you think the stock AFR valve springs with that cam might be what is causing the low power and flat power curve? It is kind of a lot of work to...
  20. C

    dyno numbers--Suggestions??

    What should the pushrod length be? This motor was purchased as an assembled long block from Central Coast Mustang so I assumed they would use the correct pushrods... BUT there was a problem, I ordered it with AFR 165s. They originally sent it to me with GT40 heads, they shipped me the...
Top Bottom
Back
Forums
Menu