Search results

My best friend is needing to know where to find a casting number on this motor besides the id tag. Does anyone know where I can find a block stamp or the head stamp?

Anyone else have problems with the outside corners of the front tires wearing really fast. I only have 16k miles on them w/ correct pressure and stock suspension. I don't understand. :shrug:

So with my mods, or lack there of, could I benefit from a dyno tune? I was also wondering about how much they cost and would they adjust my dashpot for me so that my idle comes down quicker?

I called Pep boys and they want $80 to pull a code. That just doesn't sound right to me. All I need is to know what code it is and not a full diagnostic, is there anything I can do?

I was weighting on my gear install and in an old MM&FF (i think) they had close-up pic of a TB to filter densecharger on a table, and it looked like they went down to lowes or home depot, bought some plumbing stuff, painted it black, and there selling it for like $145. :nonono: :bs: in my...

I starred Joe in the face and, without even a twitch, said... 4.10's. Only took them about 3 hrs. :nice: So I asked the guy that actually did the install what he recommends for break-in on them and he said 100 miles. Is there anything else I should know?

I noticed a slight knock/valve train rattle (kinda like a noisey lifter sound) just off idle today. It's bearly noticable and I'm just wondering if I am being too paranoid and it is just normal valve train noise or if it is a more serious issue. I just changed the oil yesterday with about...

Home dyno software $40 $40 has anyone used this or know anything about it? http://www.charm.net/~mchaney/homedyno/homedyno.htm

Will the 03 to 04 Cobra or Mach1 4v heads bolt to the same year GT?

http://forums.stangnet.com/showthread.php?t=400696

I know there is a post already about this but I'm wondering if there is any way of getting any of the prominent mustang mags to run any article at all on the issues surrounding these troubled trannys and the response that we get from the dealerships? I think that might give ford a decent kick...

mil eliminators diagram It cost me like $3 or something. Only done on the back two O2's. I didn't use the little board that it lists, but either way it's up to you. I just used the caps and resistors. Enjoy!

This is one thing that really bothers me about the mod motors is how long it takes to idle down after a rev. Do you guys know what I'm talking about? Can anyone explain this?