Search results

Hello, I'm hoping for some quick input on a possible purchase. I'm looking at a mint 96 cobra in seemingly mint condition for cheap. The owner "thinks" it has a bad head gasket because it overheats and blows exhaust smoke. I'm awaiting responses from the seller so I don't have any exact...

Picked up this 2003 GT deluxe auto. DSG with grey interior 143K miles. All original side from a Magna Flow cat back. Super clean car.

Today I picked up a 93 reef blue GT. Has a few bolt ons including BBK shorties. American thunder cat back. Bbk cold air. It’s a rust free straight car. Not without a few problems including a fall on its face power loss at wot and the need for a huge detail and a couple interior pieces.

If there are any value sites out there please direct me (side from nada/edmunds/hagerty which I viewed) otherwise I'd like to share stats on this 1989 GT hatch I looked at today for value opinions. -solid black/grey interior/5 speed/ 82000 miles allegedly/clean title -solid body and allegedly no...

Hello. I'm looking at a 1999 Cobra. Pretty good condition inside and out, 100% stock with 161K miles and only a 2 owner car thus far. In the add it is throwing a PO308 code is said to have a 35% compression loss in cylinder 8. Asking $4000. I've been reading everything from seals, rings...

Sorry for the poor iPhone video done by a 6 year old but if you have good speakers you'll get the sound pretty good. As the title says MAC cat back installed as well as an FRPP aluminum driveshaft and K@N drop in. View: https://www.youtube.com/watch?v=w91jKhzdKWc

Looking for a little insight on a chirp, squeal, or squeak noise coming from the front of the car. It's an 04 GT new to me since may. The squeal went away with a belt replacement but there is still a small chirp mostly noticeable on low RPM neighborhood driving as well as deceleration such as...

Picked up an 04 GT black/dark charcoal 5sp coupe. Going to slowly refresh it and document along the way. It's like a time capsule and was sitting for a while however was properly maintained. Straight body clean title and carfax. Picked it up for $2500. Bone stock down to the air box and...

2-15x10 Welded R/T with 275/50 Mickey Thompson ET Street Drag Radials mounted. Billet Center caps and lugs included. Only a total of 200 street miles and 2 1/4 mile passes. Bought them brand new in Sept/Oct 2009 so they are basically brand new. In the Philadelphia area looking to sell...

Just got approved for having off on 11/14 for nationals and there are no more tickets on super stallions web. If anyone could spare one I have paypal or could meet in the Phila area or if someone could point me in a good direction to try and find some. Thanks Bob

My mods and E/T are listed below. Here's where my mind is wondering....aluminum driveshaft w/18inch Mickey's on my factory wheels should get me there. Or should I be patient and save up for Bogart's then add the d/s and wheels at the same time for a solid weight reduction hopefully equal to a...

Will Weld Draglite XP's size 15 x 10 with a 5.5 backspace fit on my 06 GT? knowing that I may have to get the sway bar relocation kit. Thanks Bob

I have the Bassani X pipe that you can change from catted to off road fairly easily. I am think of switch to off road tomorrow. The impression I am under is that by doing this a CEL light may come on and that I can shut off the rear O2 with my SCT tuner to solve the problem. I have no experience...

I just ordered the Pypes mid muffler system. Anybody have this? If so how do you like it and how does it fit? I hear it may be a tight install but if your patient then its well worth it. Any comments appreciated. Thanks

When I went to the track last in Nov. was the first time I took my 06 for a few runs....my first run bone stock was 18's was 14.1 @98 which I thought it could do a bit better but I was satisfied. The follow up runs were sluggish and about 2 tenths slower each time. Now I read MM&FF where...

I am thinking of getting clear or smoked turn signal lenses and side markers on my 06 GT. Is the install easy? I can't seem to find a pdf on them as I like to read installation instructions before I even buy a product. Thanks:flag:

I am getting mixed answers of wheather or not I will need a pair of o2 extensions for my new x pipe. I bought a Bassani X pipe part # 46053 (the one with catted and off road option). I have a 2006 AUTO...some have been saying auto needs them and manual dont. Brenspeed told me that I am not...

I have a JBA axle back on my 06 GT. I cant seem to get the passenger side exhaust to line up properly, it sticks out a bit furhter than the driver side and is a bit off center in the rear valance. I've heard of some of the same issues with JBA and other axle backs and possible hanger problems...