Search results

Anyone know of a good 4.6 engine builder in Florida? My 99 GT has 220K on it. I'm looking to give it a fresh power plant.

Does anyone have any experience with light flywheels ?? What are the pro's & con's ??

I'm looking to buy a new clutch, but not sure what to get. the car is bacically stock. Any suggestions?? UPR has a King cobra kit , not sure !!!

Anyone know if there is a visible difference between OE. 2003 cobra wheels and the aftermarket detroit wheel?? I have the OE. wheels but one is bent and am not sure if the aftermarket wheel will match the others.

anyone familiar with a cylinder head repair kit made by dorman ??

Hello all. I have a recently purchased 99 gt, I have noticed that after I drive a good distance (30 to 40 miles) It gets pretty hard to get back into gear after stopping at a light. usually I can put it in 4th and work backwards to get it back in 1st but it's getting worse. It almost acts like...

Hey guys . Does any one know if the focus svt wheels will fit a fox body mustang? Or is the spacing all wrong??

I am running a 91' 5.0 engine with a carb conversion in my 85 notch. The swap was already done when i bought The car. It has a Mallory 140 gph fuel pump with a Mallory two port returnless pressure regulator set at 7 psi. I was told that restricting a pump that size without a return will burn up...

does the 7.5 and 8.8 have the same size rear drums???

Does anyone know how much power a stock 7.5 will hold ??

Hey does anyone know how much hp a 7.5 rearend will hold ??

Does anyone know about Lakewood traction lift bars? They are suppose to bolt in olace of the lower control arms. do these things really work? or should I just buy good lower control arms

I found a great deal on a set of doors off of a 91, I need to know if they'll fit my 85. they look very similar except for the trim. Didn't know if there were any subtle differences !!

this may be a dumb question but , I have an 85 notch 4 cyl that has been converted to a 91 5.0 carb'd. I'm not sure if the rearend got changed in the swap. is there an obvious visual difference between the 7.5 and 8.8 ?? please help ... :shrug:

I have an 85 notch, with a 91 5.0 motor, trans, and rearend, The motor is almost completely stock. other than being converted to a holley 600 carb. an edelbrock performer intake,under drive pulleys,mallory unilite distributor,and 2.5 inch exaust with off road x- pipe and mac pro dump mufflers...

does anyone know what an 85 notch weighs??

I need new upper and lower control arms. ( I have serious straight line traction problems. ) Blue oval industries offers a set CHEAP, but I'm not sure if they are any good. Anyone heard of them? Any suggestions? thanks !!

my buddy was running his 88 5.0 lx this weekend and broke the tranny. not sure what happened but 3rd and 4th are gone. any suggestions? can it be fixed or just buy a new tranny ?