Search results

*Will take $1000 less if I keep the nitrous kit and bottles* 0r $16000 Email me for fastest response. Serious offers will be considered. Putting it out there would like to sell for money to put towards down payment on new house. Car is one of the cleanest coupes left. Don't pass this one...

Will the flywheel only fit on one way? It is for an 88 gt. Thanks

How much difference is there in the 5w-30 and just the plain 30 weight?

I have looked everywhere and i cant find it. I have an 88gt and the turn signals dont work they just stay on so I was going to change the flasher. I thought I had found it on the back of the fuse panel but that turns out to be the emergency flasher. I was told the turn signal was behind the...

I just bought a k-member front coil over and all that good stuff. I am just needing to know the torque specs for the bolts the go from the k-member into the frame. Thanks for the help. :nice: And it was the UPR k-member and i give it a thumbs up for fitment. Looks good also.

So i am on the highway doing about 70 when all of a sudden the car just starts to cut out and then i kill it. I roll off the highway and get on a sideroad. I try to start it and it does nothing. So i rip everything apart and the cam is split just after the 2nd bearing, but wait there is no...

The car will backfire and stall right after you start driving until it gets warmed up and then it goes away. Has anyone had this problem?

I finally finished it after about 7 trips to autozone and orielys. It has a very nice lope and it feels like you have 150shot on all the time. I cant wait to hook the bottle back up and then feel the power.

I have the twisted wedge heads with the trick flow stud mount rockers. I am just wandering what the correct way to adjust them is. I have heard that you put the cylinder at the top of the compression stroke with both valves closed take all the play out of the rocker then turn it 1/2 turn more...

I am about to install the heads and it came with arp head bolts. The trick flow guide says nothing about using oil on the threads it just says to use some thread sealer then has a torque sequence of 35 50 70 then 10 more on the top bolts. Then the little paper that came with the arp bolts said...

Its finally here the track heat engine kit. I also got 30# injectors, 70mm throttle body, 75mm egr spacer, cold air kit, 75 mm mass air. I cant wait to put it on, argg its snowing outside :notnice: . Plan on dynoing after get everything running right.

I am doing a cam swap and i am down to the timing chain. I took the bolt out of the top sprocket and went to slide it off and the bottom crank sprocket is stuck and wont move. Is there an easy way to pop the sprocket off. I thought about a puller but i dont know where i would grab onto the...

I have a 88gt that is a weekend warrior only and i was wandering how much it helps if any to remove it, and how much will it hurt if i remove it.

Is their any harm in disconnectiong it. I do not have a smog pump or any of the emissions crap. Will it hurt to disconnect the egr??

I am about to buy the trick flow engine set out of summit and i was wandering if anyone has this already and if anyone has heard anything about the set.