Search results

  1. N

    Driveshaft hitting tunnel. Please help

    It is hitting the tunnel and the right side towards the top of the tunnel. , not the loop at all. Loop is 6'' away from the yoke. you think it might be cause the convertible motor mounts. The motor would be lower, transmissin would be faceing up more? I'am lost
  2. N

    Driveshaft hitting tunnel. Please help

    Alright, I did all my suspension work at the same time. I put in a 8pt cage, subframe connectors,90/10 front,50/50 rears, Eibach drag launch spring kit with air bag. Ford racing uppers and Lakewood lowers, non adj. It has Convertible motor mounts and a stock transmission mount. I have a UPR...
  3. N

    306, Vortech 5psi HELP

    It has a Granatelli mass-air.
  4. N

    306, Vortech 5psi HELP

    My buddy has a 302 .30 over afr 185's Vortech 5psi supercharger. 30lbs inj. fuel pressure with vac. line off in 40. Has a 255 fuel pump. FMU. Timing is set to 10' .The car will not idle for ****. TPS is set at .99. Base idle is around 800rpm. Idle starts surgeing up and down then shuts off...
  5. N

    Setting T/B and F/P on Supercharge motor

    I am trying to get all my settings right on my 92 GT. I have a 70mm T/B. What should the TPS be set too? Also I am running a small vortech (5psi), with 30lb injectors. WHat should my fuel pressure reg. be set to? Motor is 302 .30 over, GT-40 intake, AFR 185's, 70mm T/B, 76mm mass-air, 30LB...
  6. N

    Mileage counter quit on my 94 Cobra

    Could the speed senor that the speedo gear goes on go bad?
  7. N

    Mileage counter quit on my 94 Cobra

    Yeah, but it work two hours before the old tranny came out. I check the plug and all is good.
  8. N

    Mileage counter quit on my 94 Cobra

    Mileage counter quit after NEW Tranny was installed this past weekend. Speedo works still. What could it be? Thanks for any help
  9. N

    Eibach Drag kit, plus some Questions

    This weekend I did some suspenion work to my 90 Gt. Had all stock before. I put on the Eibach Drag Launch kit, Lakewoods 90/10 front, 50/50 rears, lakewood lower control arms and ford racing uppers and full length subframes connectors. I boxed in my battle boxes also. Like I said I had all stock...
  10. N

    Carb/intake question

    I had a Victor Jr on my car and today put back on my Performer RPM back on. It runs kinda of rich, but it does most of the time anyways. It runs good and does not bog at all. Should I have it adjusted or leave it? I am asking because when I spray it. Will it be to much fuel or no? I figure...
  11. N

    What should my 94 Cobra Run 1/4 mile

    Well, I can drive. lol... Speedworld aka Spinworld was kinda half decent lastnight. First pass went [email protected] with 1.98 60ft launched @2500rpm 2nd pass [email protected] with 2.0 60ft launched @3000rpm 3rd pass [email protected] with 1.89 60ft Launched @3000rpm All was done...
  12. N

    What should my 94 Cobra Run 1/4 mile

    I am going Friday Night
  13. N

    What should my 94 Cobra Run 1/4 mile

    Going to Orlando, Speedworld
  14. N

    What should my 94 Cobra Run 1/4 mile

    Just wondering what you guys think it will run. Mods listed in sig. Thanks
  15. N

    Can I toss the Weight on Clutch fork 94 cobra

    Will it mess anything up if I take it off? I am used to messing with fox bodies that do not have them on them. It is a pain to adj. the cable with it in the way. Thanks
  16. N

    Who makes the Speedo cable eliminate plug???

    Just like this one. http://mustang.c-f-m.com/index.asp?PageAction=VIEWPROD&ProdID=1106
  17. N

    Who makes the Speedo cable eliminate plug???

    Who makes the Speedo cable eliminate plug in to the tranmission? I remember seeing in one of my old MM&FF books but I can not find it. Thanks