Search results

I always wanted to find a place to incorporate this back into the car. I think it looks good. The stock radio sounded like butt anyway and the car sounds much better:D An outside pic just for to whore the car alittle. And the reason the radio was useless:D

Decided to go back to the stock 16's. IMO they look the best on this car anyway. It took me awhile to find some but with patience I got lucky. I do have all center caps but forgot one at home when these where taken. These street tires are absolutely useless from any kind of roll in 2nd or 3rd...

I havent been on the boards in awhile so I figured I would post a few pics of my 89. I sold the 03 awhile back and ended up in this. 80k miles and a decent amount of mods. I am also looking for 1 16x8 5 spoke ARE wheel. I have 3 but one was damaged. Man, its almost imposible to find these!

I ran a new best at Beech Bend race way 60ft........1.68 1/4........12.68 MPH.......106.64 New best 1/8th at Union Hill 60ft........1.60 1/8th.....7.96 MPH......84.55 This is in my NA 03, only mods are Mac LT's, 70tb and plenum, cai, 4.10 gears, built rearend and slicks:D

Well the good thing is my car went [email protected] :banana: which is a new best. But the bad news is I blew the rearend on the 3rd pass. I put my foot down and launched off the rev limiter with the 26x10 ET Drags on. BOOM!! Broke the spider gears and lost a c-clip. Now its time for a built rear...

Sometimes after driving my car for awhile it wont start back up. Its like I'm not pushing the clutch in. The battery if fine and it does not click or anything, it just wont do *****.:bang: WTF Could the starter be getting hot and fouling up? I dont want to take it to the dealer because of my...

My car will not start??????? My passenger side manifold where it meets the x-pipe has been leaking condensation for a couple days. :bang: Could the water have leaked or spued on the starter??? I heard the starter is on the passenger side near the x-pipe? The car has plenty of battery. The...

I can get a set of Modmax billet cams for 300$ These are Stage 2 N/A cams. specs [email protected] .525 lift [email protected] .575 lift I have to make a decision pretty quick. They are in perfect condition and have less than 1k miles on them. Should I get comp springs with this? Any suggestions please.

[email protected] .525 lift [email protected] .575 lift I've found some for sale and wondering if these would be a good choice. They have less than 1k miles on them. My mods are in sig. I will also be going 4.30's.

My tire guy says they will fit. I want the BFG DR's in a 295/35/18. I dont want Nitto cause there not as wide. Will this work??

This was a 14.03 and I beat a 99 cobra My best was 13.9@100 Yes-I'm N/A

I took off that ugly honeycome and horse grill.(looks much better) But what do I do about the four holes that was holding the bottom down? My car is white so it looks like something is missing. :( Is there any king of white circle stickers I could put there or do I have to buy a grille...

Atleast I beat a 99 cobra (stock with exhaust) I dont think I did too bad considering 90 degrees outside, stiff susp, and 265/35/18s My best was a 13.9 @ 100 this run was 14.03 at 99 If it dont work I'll try again.

I'm running in the 1/4 tommorrow and wondering what you guys think I should run? I'm on Pirelli 265/35/18's and mods are in sig. Thanks

Would a steeda timing adj help my car. I dont know if Saleen bumps their timing or not :shrug: I've added a upr o/r-x and TFS plenum. TB is next. I need more power but dont have funds laying around for sc, cams, or heads yet. I lost some torque with my o/r x-pipe over the stock catted...

I feel a torque loss with my o/r x-pipe. It feels a little stronger up top. The sound is amazing from my upr o/r x though. Do you think a TB and steeda timing adj would help. I dont know how much Saleen bumps their timing in the 03's? Or do they at all? What else can I do for a little more...

If I disconnect my battery to bolt up a UPR o/r x-pipe and do the MIL elim is that gonna mess with the Saleen reflashed computer? And is this a actual magnaflow catback on the car stock and will the o/r bolt up to it? Will I pick up good results from this? I definately want it louder.

Anybogy using the BBK tb?? I installed my TF plenum tonight :nice: I'm either gonna go bbk, frpp, or accufab? (70mm) Wheres the cheapest place for throttle bodies?

I have magnaflow 2.5in catted x-pipe and magnaflow catback. I'm thinking about going with SLP. I want a loud ballsy monster!! Since I already have a 2.5in catback can I just weld in the SLP's??? This is the exhaust that came stock on my 03 Saleen. I like it but its just not loud enough for...

I've got 265's in back and 255's up front but I would love to go 295. My tire guy said he could get them on no problem. What do you guys think. They are 18x9's.