Search results

  1. 1991vert

    1991 Convertible Top Frame Question

    Its part# 296a01...Google search turns up empty handed or some web page in Russian
  2. 1991vert

    1991 Convertible Top Frame Question

    So I need a gasket that attaches to a piece of the top frame. It's the channel that runs vertically along the rear of the quarter window. I'm not sure exactly what that piece is called. It's removable with 2 bolts attaching it to the frame . The gasket piece is riveted to the unnamed piece...
  3. 1991vert

    Convertible Top Motor

    They don't have an o-ring kit listed, but I'll try emailing them
  4. 1991vert

    Convertible Top Motor

    Anyone know if I can purchase an o-ring for the reservoir? I replaced both of the lift cylinders and when I went to remove the fill plug, it broke. Half of it fell inside the reservoir so I split it open to remove it. I purchased a new plug, lubed the o-ring and reassembled. Well all of the...
  5. 1991vert

    3G Alternator Install: A How To

    Well, that fixed the issue. Thanks for your help!
  6. 1991vert

    Convertible Top Motor Repair

    i know this may sound dumb, but have you tried looking at videos on youtube? there may not be a specific video for what you're wanting to do, but one may be very close.
  7. 1991vert

    3G Alternator Install: A How To

    testing both sides of the connector, each measure at .3-.4. so from the D-plug to side A of the blue connector and then from side B of the blue connector to the dash. It had to have been the blue connector, right?
  8. 1991vert

    3G Alternator Install: A How To

    there's a blue connector that has some green sludge in it. I will try cleaning the blue connector along with the connector at the dash and the alternator. Hopefully this will solve the problem. One thing I did notice when I was taking the wiring out of the loom, the green wire looks like it...
  9. 1991vert

    3G Alternator Install: A How To

    Without touching anything it now reads 1.3-1.4. I literally turned it on without touching anything from the prior reading
  10. 1991vert

    3G Alternator Install: A How To

    By touched I mean extended
  11. 1991vert

    3G Alternator Install: A How To

    The contacts looked clean on both ends and none of the stock wiring was touched. I did have to solder the green/red back together after removing the wire that runs to the master switch in the rear. I wonder if I take a pin and test it after the soldering joint if it will read different. I...
  12. 1991vert

    3G Alternator Install: A How To

    I set my digital meter to Ohms and with both wires disconnected from their harnesses, it read 4.1 - 4.3. After leaving it for a few minutes, it settled at 4.1. What is this indicative of? I appreciate your help and your patience, Chris
  13. 1991vert

    3G Alternator Install: A How To

    Where should i start looking for problems in the battery light indicator circuit? I've unplugged the alternator D-plug and plugged it back in. Should I start with some dielectric grease? The cluster is from the factory, so the wiring is the same. I have my wiring exactly like the moroso...
  14. 1991vert

    3G Alternator Install: A How To

    Tell me what you make of this... I've had a battery light that will come and go. Driving, sitting at idle, doesn't matter. It's been going on for a couple of years and I can't find out why. I have a PA performance 130amp alternator and an optima redtop which it located in the trunk with a...
  15. 1991vert

    Driveability Tune For A Bs3

    if i take the vacuum off of the bypass valve, it's solid. it's blower surge
  16. 1991vert

    Build Thread Finally Got Some Work Done - 56k Death

    dont forget in and out of the garage and on and off trailers! any plans on coming home soon?
  17. 1991vert

    Build Thread Finally Got Some Work Done - 56k Death

    I haven't updated this in quite some time, but the car ended up making 670rwhp/655rwtq @ 17psi with some belt slip
  18. 1991vert

    Driveability Tune For A Bs3

    tuner added fuel while in closed loop because i had something odd going on with the car. i could barely get it off the trailer. curious if that's what causing it
  19. 1991vert

    Driveability Tune For A Bs3

    yes i have an IAC. once the car is warmed up, it's fine.