Search results

Long story short I've had loads of exhaust leaks, this sounded like the headers leaking on the drivers side head. Today I accelerated and BOOM! Then it sounded like I'd shred a belt. No check engine lights car running fine... Pop hood and one of the coil pack tubes is blowing around...

I'm assuming I need a new front pass. side wheel bearing as I have a pile of grease (assuming) inside both sets of wheels and a slight grinding noise (almost sounds like tire road noise but it's the same with either set of wheels and tires and I've changed the brakes and it's still persistant)...

I've seen a few repair kits for the calipers on Rockauto and teamfordparts, but they don't say what all they fix and what's needed for the install process. I'm fairly certain now that one of my istons is sticking, while I do have a pair of brakes inbound to replace, I'd like to fix my current...

Figured I'd try here before I go all out and replace everything. Long story short I bought Powerslot slotted rotors and Hawk pads all around. Only installed the fronts. Brakes are bled, and everything passed an inspection post install at the mechanic. The problem is the front right has a...

After just getting back from a deployment I had a bit of extra cash and decided to change my billet Bullitt style fuel door to the black GT one American Muscle offers. Any way when I installed it one of the c-clips and bolts stripped out. I didn't think I over torqued it. So I contacted...

There's not a single thing I don't like about this car. That being said I do like the 2010 alot, I just think the rear needs a different bumper for the new lights. Autoblog

Not your normal ID thread. My local group here in the UK is trying to find out what the story is behind offset stripes. One of the members had this toy (or one similar) growing up. Mettoy Corgi diecast No.325 Ford Mustang Fastback 2+2 1965-69 After a lot of google searching I can't find...

Just realised after looking through some sites... he's sponsored by a company that has a Stang Drag car :) Albiet he does the whole kite boarding thing... Florida Kitesurfing Still pretty cool though when I've been nagging him to join the Military for college and he's most likely...

I did a search. The only other thread wasn't exactly helpful. Any way I have 99 Cobra lights being installed at a shop right now and I didn't pay attention and realise the Mustangworld install instructions refer to a kit that is no longer made. Any way I have ordered a 99 Cobra Flasher...

A while back I ordered a new chin spoiler from them because my old one (of about 3 years) was all banged up. Any way I installed it last week since it's supposed to be done snowing. Then yesterday it kinda dissapeared some where between my house and my G/Fs about 70 miles away. I'm guessing a...

On my 03 I need to hide the Amp and Cap. I was thinking of usinf alchohol to clean under the seat good, and then using 3M tape for the Amp and also 3M on the Cap bracket. Any reason this is a bad idea? Other idea I had was super glueing wooden rails to the underseat panel and then screwing...

I think any way. I would like to think that I pay attention to every aspect of my car, but there is a chance I've just never noticed before. Any way at any speed the shifter rocks forward and back what seems to me like a lot. Maybe up to 1/2" but more likely about 1/4" of play either...

Well first time to the track since the blower... Old N/A best... 14.4 @ 98 AVG times 14.6 @ 96 First runs, not so great. Then I clicked off the 13.9 @ 105 but I'm still not happy. (I know the 14.5 run I spun 1st and 2nd) we did have a strong head wind until the 13 run, but that's not a...

I searched but I either suck at search or I couldn't read through the enormous SeaFoam thread. Any way is it safe to run SeaFoam with a Centri Blower? I figure it should make no difference as long as you blow the gunk out at below boost RPMs? But on the other hand any residual could end up...

I can't find a single site that sells only rears. At this point I could care less if Steeda, FRPP, or whatever. I just want a good rear drag spring and maybe 1/4-1" lower.

Thanks Modular Power House Prior numbers with full bolt ons were 265/315 (The only run file I had on my PC with the N/A numbers is 262/302 prior to my BBK shorties) New numbers with the Novi 1200 SL Mongoose kit are 360/360 (avg) Mods with the blower are BBK Shorties, Accufab 75mm TB...

Went to replace the PCV (stocker at 65k I know I'm bad), any way damn thing was hollow. I started up the engine after the swap with the new part to make sure there were no new noises, but nothing other than what I've always thought was noisy ticky heads (both heads do... and I've been told...

05+ guys may have us beat... http://forums.stangnet.com/showthread.php?t=741770 So much cooler than "Can my Stang beat _", "I just got $____, what should I buy", and the infamous "What wheels" threads.

That 1. Have an amber (not red) turn indicator) and 2. Don't look like ass I've seen a few that have amber, but they look like butt or are universal. I'm looking for something that looks good on a Stang AND has the amber... I'm moving to England and trying to get my lights legal for over...

I know winter is almost over for alot of us, and some of us have a few more months of snow to go. Every year we get an abundance of snow threads, would a Snow sticky be a good idea? I dunno. Any way I was thinking people could list thier tires, and driving advice, whatever. Personally I...