Search results

  1. dgollem

    Putting 1991 Hatch on 1986 Car - What Size/Thread Hinge Bolts?

    Could be metric these cars are a mismatch of SAE and Metric.
  2. dgollem

    New here, Ford master tech from Kansas

    Why got go on the spray and use nitrous?
  3. dgollem

    Paint and Body Restoration prob

    Unfortunately good paint and body work is really expensive these days and fox mustangs are usually not worth the money it cost to bring them back . Even with FOX prices going up it is not uncommon to pay $10 grand just for a fair to good paint job. Even MACCO is getting $2 grand plus just to...
  4. dgollem

    Electrical Oil Pressure gauge issues

    Not yet but is has been acting up for several thousand miles.
  5. dgollem

    Electrical Oil Pressure gauge issues

    Having issues with my Oil Pressure gauge. It has started jumping around erratically, more than if it was and oil pump issue. I changed the sending unit, no change, just changed the gauge, no change, and then changed the entire cluster, no change. Any Ideas?
  6. dgollem

    Hello All! - Need Shop Recommend for Maryland

    What part of Maryland? There is an independant shop in Waldorf called Myers that most people have good luck with. Also Justin Performance Center JPC in Denton MD
  7. dgollem

    Paint and Body Paint quantity

    It will work but it may not last, Are you going to clear over it. Also a gallon may not be enough for a color change. When you add hardener and reducer you end up with almost 2 gals of liquid. That is enough if you know what your doing and do not have any redos. I'm an amature and barely got...
  8. dgollem

    Gauge panel plastic polish

    You can also get some good plastic polishes as a motor cycle shop I've use them all the time for helmet visors and bike winshields.
  9. dgollem

    Aftermarket Sound System

    Check out Crutchfield. They have a lot of units that will work. I put in a pretty basic Kenwood unit a few years back and it has Bluetooth hands free for the phone and a USB input for MP3s as well as a Cd player. Also upgraded the speakers with some that fit right in the factory positions...
  10. dgollem

    What's it Worth? 2014 California Special with Roush Phase 2 Kit

    Tough question There are two Bosses advertised here in Maryland a 2012 for and a 2013 at $30k. 2013-14 GTs are around 20k. I know apples and orange's because of the super charger and your location but $20-30K may give you a starting point. What does it cost to add a stage 2 roush...
  11. dgollem

    JRichker -- Rest in Peace

    JR May you receive all you deserve and more as you rest in peace. Thank you for your service to our country, your community and Stangnet . May peace be with your family and friends.
  12. dgollem

    Brakes Is my caliper piston moving enough?

    Normally they move a lot more than that, they can even come all the way out with no pad and rotor to stop it. UNLESS you have a lot of air in the lines. Did you open the system and let any air in? If so I would put it on with pads and rotor and bleed the brake then check it again.
  13. dgollem

    Engine Trying to remove crankshaft pulley bolts

    Heat the bolts. The internet says to about 500 degrees, you can use a propane torch. Some times striking the wrench with a hammer will transfer energy without rotating the crank assuming you cant fit an impact gun in there
  14. dgollem

    Engine Please help !!

    turning the distributor has nothing to do with priming the fuel pump. You said the engine was rebuilt 500 miles ago. I would double check the wiring harness going to the distributor and make sure its did not get crushed/pinched and is causing a short. The check list is a great tool.
  15. dgollem

    Blowing pip sensor

    Bad luck, cheap part? Might be worth trying another one.
  16. dgollem

    Engine Please help !!

    Just a thought but make sure you don't have a bad wire in the distributor harness. Does the harness get slack at 20 degrees and pull tighter when you back it off to 15. Could be something simple. Timing should not cut off spark only determine when in the cycle it occurs.
  17. dgollem

    I hate removing old tint!!

    Plus 1 for the steamer method also dawn dish soap and patience to let it soak will help with any glue residue, I've found it to work better than goo gone etc, just messy. I have split the difference and gone with really light tint to get the uv protection for the rest of the interior Nice Car!.
  18. dgollem

    Is there a 79 Foxbody with an AOD from the factory?

    Here is an article that might help. https://www.hemmings.com/stories/article/the-ford-aod-transmission From the article: "Ford redesigned the C-4 into an overdrive automatic to lower highway driving ratios resulting in better highway MPG ratings. They called this replacement transmission the...
  19. dgollem

    Drivetrain Searching for a clutch

    I have had good luck with centerforce
  20. dgollem

    LMR hood insulation review

    Thanks for posting I was on the fence if it was worth it. I'm gonna get one now.
Top Bottom
Back
Forums
Menu