Search results

Does anyone have the outside dimension of a 2003 Mach 1 gas tank. Not capacity but dimensions. I am assuming that all 99 - 04 gas tank share the same dimensions. I am thinking about installing this tank in a highly modified 68 Mustang, along with it's matching trunk floor with the spare tire...

Can I install just the axles in the rear housing without the centre section so I can bolt on wheels and tires for moving car around shop? David.

My new lower control arms do not have the sway bar bushing seat installed in them, in fact I have never seen a new set with them installed. How do you remove them from the old arms? How do you reinstall them in the new arms? Where do they install, on top of or on the bottom of the arms? My...

Has anybody tried putting the oil pressure guage from the standard guage cluster in place of the clock in the deluxe tach cluster? Is it even possible with the different wiring? David.

It is my understanding that Ford wired their tachs differently than aftermarket tachs. I am putting a painless harness in the 68 and can't find anything on how to wire the factory tach. Is the factory tach compatible with the painless harness? Also, if I do decide to upgrade to aftermarket...

Starting work on the brakes on the 68 and I was wondering if it would hurt anything to sandblast the entire rotors, brake surface and all? Would the sandblasting leave an uneven surface, similar to a warped rotor or would it be fine if I took it easy? The rotors have quite a bit of surface...

Will the throttle pedal and cable linkage from a 1980 Versailles fit in a 68 Mustang that is going to be converted to EFI? I know the popular swap is a 69 - 70 pedal and a fox cable, but there just aren't any parts cars available up here.

I know there is a lot of talk about the supposed introduction of the Lateral Dynamics and Evolution Motorsports 3 link setups in the near future, although we have heard that for awhile now. Has/is anyone used the RRS torque arm 3 link rear suspension setup? The main reason that I ask is that I...

Just wondering if anyone here has or know anyone with either the Richmond 5 or 6 speed trans in a 67 - 68 Stang. My original plan was to use a tko 500 or 600 behind my 390, but with all the talk lately about bad driveline angles and cutting of floorplans to make it all fit properly, I have been...

Except for the price, could this, part #10-59, be the ultimate Master Cylinder, power booster, metering/proportioning valve, hydralic stop light switch? Chcck this out. www.abspowerbrake.com/ElectricHPpage.html. Has anybody used this system in a classic Mustang? Does it work as good as it sounds...

Has anyone installed the Ron Morris Performance front coilover kit on their 67 - 68 Mustang? How does it compare to the TCP, Unique, Global West setups? I am considering such a conversion, but it seems to me that the lower control arm on the Ron Morris may be a bit weak. Any ideas?