Search results

  1. M

    Pro Flo PFT-77 Calibrated for 24

    I am needing the MAF curve for this MAF sensor. I bought this car recently and it has this MAF sensor with Yellow Top (19lb?) injectors. I have searched the internet and found nothing. I am hoping someone can help me out here. Thanks in advance!
  2. M

    Tires

    I bough these gererals (z-rated) and for the money ($78 a peice) I cannot complain. My GT is supercharged (KB), they spin a little easier than my previous (BFG KDWS, only lasted less than one year and ~15K miles), but I spent $500 on the BFG (which were sticky). They have a much better ride...
  3. M

    Supercharger Install

    I istalled my KB w/ a freind and basic tools in about ~10hrs from start to boost
  4. M

    Pre-Kenne Bell

  5. M

    Pre-Kenne Bell

    :D I am running 6psi and have had no problems. Stock clutch, rearend, tranny. I never drop the clutcy in 1st becase you would just sit there. If your foot hits the floor in 1st you are smoking the tires and hitting the rev limiter. I do power shift 2nd and 3rd quite a bit though, clutch is...
  6. M

    Dumb Question about a manual and 1st gear

    1st gear doesn't have sychro's
  7. M

    Kenne Bell question

    My wife drives mine also, she too never gets into it. I wish she would so I could hear what it sounds like taking off. She never leans on it when she takes off. I always tell her so I can hear the exhaust also. But like stated above, you don't even know it is there unless you lean on the...
  8. M

    POWER CURVES: N/A vs. S/C & Turbo

    Here we go again!!!! The power curve of the twin screw will resembele the stock torque (straight and flat) curve were as the centri will gain more torque as the rpms climb. I am not going to comment on the other question, there will be flaming everywhere, good luck w/ that. :nice:
  9. M

    Stock Rims -> Wider, but still safe, tires?

    275 are fine, plus it will give you some more rim protection. I had 255's and went back to 245's (wasn't thinking :bang: :bang: ), next time I am wanting to go 275 in back and 255 in front(maybe, we will see how these tires wear w/ the KB, I have a feeling I might want two more tires the same...
  10. M

    Where should i be Shifting?

    I am not sure if it would change w/ your type of S/C, but stock I shifted at 5500-5600 and ran a 14.2 (1st time at the track). I have done a lot of reading and found this to be the best for a stock engine, but you are right, w/ a centri S/C, I am not sure if it would be worth it to shift at a...
  11. M

    Premature Wiper Spray Squirting

    I have the same problem, but it only happens once and awhile. Doesn't happen enough for me to worry about it right now, when it happens, I pull out on the end of the blinker switch, I am sure it is just like explained above.
  12. M

    Oh No! I have the dreaded CC plate Clunk!!

    It is the sperichal bearing like he said, bump steer would not make this noise. I had Pro3i plates and they had to send me a new bearing, mine was loose, they said that most of them were to tight and they would stick and then snap loose to make the noise. I have measured the effect of...
  13. M

    Mach 460 Sound System

    Don't get me wrong the factory speakers are awesome, I put them in my 98 SHO and it made a world of difference, just be careful when doing this stuff so you don't fry your factory amps, just incase you want to ever put the stock mach .460 back in.
  14. M

    Carbon fiber hood

    :flame: :flame: :flame: :flame: :flame: :flame: :flame: :flame: :flame: J/K to each there own. :D
  15. M

    Weird noise from front suspension..

    Check your sway bar linkage, it will make that noise when it is going bad.
  16. M

    Mach 460 Sound System

    I did my system before, it was a pain. The system in our cars is set up for 2 ohms and almost all aftermarket are set up for 4 ohms. Your speakers will miss some beats, mine did. The harness that I got bypassed the amps. I ended up just running new (bigger) speaker wire thruought the car...
  17. M

    Removing speakers

    In the Mach 460 systems, they have 5X7 in the bottom part of the door and I think they have 2" tweeters in the corner. The corner the screen just pops off and the ones on the bottome you need to take the inside panel of the door off.
  18. M

    physics guys in here for a sec

    I have taken quite a bit of physics, but I don't think it is that complicated. I think it comes down to simply cooling the intake air thus not allowing the temperature inside the cylinder to reach it flash point. So w/out the help of the spark, there would be no fire. If you think about it...
  19. M

    anyone else with throw-out bearing problems?

    I would have thrown a coniption fit if they did that to me. I would go right to the top and rain hell on them. :uzi: :flame: I am mad and it is not even my car.
  20. M

    Drivers Door Rattle

    When I installed my new speaker in front, I looked. But it seems when the window is all the way up, the door appears to flex a little, and this is the only time it is doing it. It did before my subframes and after. It almost sound like the glass is hitting on something. It drives me nuts, I...
Top Bottom
Back
Forums
Menu