Search results

  1. T

    Hiccup

    Ya we played with the timing a bit but didnt help. Basicly whats happening is if i open the throttle fast the car takes a sec to react. Im gona try some other things ive read about on the page today and see if that helps corect it. but if anyone else has had this problem any other insight...
  2. T

    Hiccup

    Slow throttle response has my going nuts ! Hello,I recently added a new Cam and a set of Trickflow TW heads to a Factory 302 block. it has trickflow intake 24" injectors and a few bolt ons. After the instalation of the cam and heads i discovered a hiccup when you press the gas pedal fast...
  3. T

    when i stomp it n go over six grand

    Yea,it runs rough at hi rpms but not rich the O2 sensors regulate mixture n the mils should be reading very low emiss if any, maby ita vacuum problem
  4. T

    when i stomp it n go over six grand

    Yea,ok thanks for ur help guys ??
  5. T

    when i stomp it n go over six grand

    Ok,this site must be for old people(woodster)if u dident have an answer y did u respond ,to make fun??hea i got a question more ur speed y r 93 floor mats so hard to find?? r=are
  6. T

    when i stomp it n go over six grand

    When i stomp my cobra n go to high rpms :banana: :banana: :banana:
  7. T

    header install,use factory bolts or no

    Im doing a header install on a 96 cobra i almost got the passenger one off when it started to rain (hard) so i packed up for the day i hear of bolts backing out n all that but the bolts that came with i realy dont trust should i just use the old ones
  8. T

    Found oil consumption problem....

    Ive got oil in my coolant,small beads 96 with 86thou when i use val- it burn it but with cast- it seems fine havent tryed mobil yet
  9. T

    Check Engine Light

    Yea,just change the frount ones i got new ones n it made my car run so much better the first two control ur mixture n the back two check for emis- n to make sure the cars hot to burn the unburned gas, i had that same code i had wire in mils i pulled em n got the steeda ones they work but there...
  10. T

    Oil in degass bottle small beads in my coolant 96 cobra

    common u ford guys Yes, i used water weter n thought of that so i put 50/50 water/ coolant in a milk jug and added water weter ,it blended right in,but thats a good call thanks for ur reply i live in florida it was around 90 today heat could be a factor (under what tempatures have u seen that...
  11. T

    Clearance after shock install

    Hi,i think its the toe i rub to n im goin with 2in ball joints n bump,steer kit without that stuff ur wheels r only centered when goin strait when u turn the top of the wheels toe in tward the car
  12. T

    labor cost for spring change

    yea,what all those guys said pluss,u have to have to have an air wrench to break the nut on the strut but the best part is u need caster-camber plates ,bump steer kit 2in ball joints its a fun project but if i had it to do over ied just get larger rims m2c
  13. T

    Oil in degass bottle small beads in my coolant 96 cobra

    Hea,any help would be usefull before i go n start tearing stuff apart i have small oil beads in my coolant is this a bad oil cooler or blown head gasket my oil looks great n i dont realy beat her up that much (no smoke)( no idea)
Top Bottom
Back
Forums
Menu