Search results

  1. Jsun3701

    PCV problem?

    The passenegr side PCV hose near the valve cover is crushed under a vaccum. How do I replace the PCV. I cant seem to get it off?
  2. Jsun3701

    Squeaky throwout bearing ?

    White lithum grease, all day.
  3. Jsun3701

    Tire, question

    Alright before I buy them just to make sure 275/40 17 will fit the stock GT rims. Front and rear right?
  4. Jsun3701

    Changing tranny oil questions

    Curious what does the mustang Owners manual say for capacity for the 3650?
  5. Jsun3701

    Changing tranny oil questions

    Not to start an arguement, the reason I say pull the shifter. I was under the assumption you had ramps or maybe a set of stands. If you have it good and can put your car on a ramp, by all means thats the way to go, youll get the majority of the fluid out. I would imagine almost all. But if you...
  6. Jsun3701

    Changing tranny oil questions

    Im sorry, I meant dont snake the hose to the fill hole on the tranny. Just take the shifter off and fill it from there. Also if you do a search most people run approx 3.1 or 3.2 quarts. Because I believe the manual tell you to use x amount of liters which equals 3.4 or 3.5 quarts. A lot of...
  7. Jsun3701

    Changing tranny oil questions

    I have done this on my GT twice and on a MACH 1 twice. Dude pull the shifter and fill it from there. Dont try to snake a hose to the shifter. Its not hard to pull the shifter. Its so much easier than using the fill hole. Also put in some Lucas oil if you want to, cleaned my shifts quite a bit. I...
  8. Jsun3701

    Long tube question

    I have a engine hoist , would it be easier to disconnect the motor mounts and transmission, hoist the engine out to install the headers. Then lower back in? I know I would have to disconnect the Radiator and isnt that about it? Has anyone tried this or have any input on the idea.
  9. Jsun3701

    Made the switch

    :D I made the swith to Synthetic. I used Pennzoil 5-30, it was buy one get one free? With the morotrcraft fliter and a quart of Lucas full synthetic additive. My early morning piston slap went away my engine runs much smoother and quieter. Totally satisfied.
  10. Jsun3701

    Changing to synthetic, weight reccomendations?

    You found that a syn 5-30 is better than a Dino. 5-20?
  11. Jsun3701

    Changing to synthetic, weight reccomendations?

    Im changing my oil to synthetic before I drive to Philly this weekend, reccomendations on what weight I should use? Yes Im using the Mobil 1 filter. Also throwing in some Lucas. Not looking to start a long thread, just asking if you have made the switch, what witch weight gave you the best...
  12. Jsun3701

    help! faulty throw-out bearing

    Make sure the clutch is aligned properly. Just saw a guy with a relatively new center force at the shop the other day. He didnt have is clutch aligned properly, after 5k you could see the wear on the pressure plate and the throw out bearing was hosed.
  13. Jsun3701

    Idle issue after plenum/tb install

    Check this thread for a pic of the hoses to check.http://forums.stangnet.com/showthread.php?t=675490 Hope this helps.
  14. Jsun3701

    Idle issue after plenum/tb install

    Dude check your vaccumm hoses, its very easy to mix them up.
  15. Jsun3701

    Clutch feels odd

    Does it feel like a stretched rubber band?
  16. Jsun3701

    Passenger Airbag Cover?

    Take a head rest.
  17. Jsun3701

    Pulleys what is the difference

    Go Steeda or go home. I put my steeda pullies in not too long ago. I think the biggest change has been in mileage. I took a 300 mi trip right after I did my install and I recorded a 1-2 mile a gallon increase. The car revs a little quicker, but no huge power gains. I havent used a tank in town...
  18. Jsun3701

    Videos of different exhaust combos???

    No , never heard of them . thanks.
  19. Jsun3701

    Videos of different exhaust combos???

    I am thinking about making some changes. I got the itch. So I know long tubes but which ones? It might make a good thread if people put recordings of their cars and listed the exhaust combos. I know people describe their combos but audio would be fantastic. Also I have access to a engine hoist...
  20. Jsun3701

    Thinking bout the switch Petro to Syn oil

    Still use 5-20?
Top Bottom
Back
Forums
Menu